Get matched with top door pros in Jefferson, SD

The best direction for a gate to swing depends on its location and purpose, but swinging inward is the general rule. An inward swing is often considered safer, prevents the gate from opening into public spaces like a sidewalk, and may be required by local building codes.

There are exceptions and specific considerations. If your property is on a slope, an inward swing might not be possible. For a deck gate, it's safest to have it swing away from any steps. In a backyard, the direction can be a matter of preference, though an inward swing can be helpful when carrying heavy items like a wheelbarrow into a garden.

Regardless of direction, ensure the gate can open fully without hitting any objects or blocking spaces. While an inward swing is standard, a gate that can swing both in and out offers the most flexibility if your setup allows for it.

While applying a small amount of olive oil to a door hinge may not cause problems, regularly using olive oil or vegetable oil can cause door hinges to become sticky and gummed up over time. Additionally, residue from food-grade products can actually turn rancid.

To build a standard size, six-panel door yourself, you’ll need four 2-foot by 6-foot boards, one 2-foot by 8-foot or 2-foot by 10-foot board, and a sheet of 3/4-inch, paint-grade plywood. The 2-foot by 6-foot boards will serve as your stiles, top rail, and horizontal and vertical mullions, and the wider board will serve as the bottom rail, which is usually wider than the other horizontal pieces. The plywood will serve as the panels, but you’ll need around five 1-foot by 6-foot boards to make your own panels if you want to stain the door rather than paint it.

You can use a variety of wood to build a barn door, but the most common options include 1-by boards and 2-by boards for the backing and the decorative boards on the front of the door. Softwoods like pine will save you some money and should hold up well, while hardwoods like maple and oak will stand up to more wear and tear. You could also build the backer out of plywood to minimize the cuts you need to make. Whatever you decide on, make sure the width of the wood is compatible with the mounting brackets you buy.