Get matched with top stone and gravel pros in Bryant, SD

Some older brick material is extremely hard, making it tough to create a hole. Rather than using a typical wood drill bit, always use a masonry drill bit when drilling into brick. For extremely hard brick, using a power drill with a hammer function may give you better results. The drill bit will heat up as it goes into the extremely hard brick, so you may need to stop after a few minutes and allow the bit to cool before starting to drill again.

Yes, bricks can crack over time. While spotting a crack (or several) might be nerve-wracking, cracked bricks aren’t always cause for concern. In fact, it’s normal to see a few small cracks as your foundation settles. However, if the cracks are getting wider or longer or you keep finding new ones, you should have a masonry professional inspect them right away. You should also contact a pro if you notice any large or vertical cracks in your bricks.

No, you don’t need to soak the brick before cutting it by hand. In fact, cutting a wet brick can make it harder to see your score lines and may cause the chisel to slip. Soaking is sometimes used with power tools to reduce dust, but for hand-cutting, it’s best to work with dry bricks for better control and visibility.

Granite is the strongest commercially available stone houses are built from. It’s also more commonly available, which means transport costs aren’t as high because a granite quarry isn’t too far from a build site. Limestone and sandstone are popular materials as well, but they aren’t as strong or weather-resistant as granite.