Top-rated bathtub restoration pros.

Get matched with top bathtub restoration pros in Grover, SC

Enter your zip and get matched with up to 5 pros

Need a pro for your bathtub restoration project in Grover, SC?

Select your specific project to find the pro for you.

Find Bathtub restoration pros in Grover





Avatar for American Tubs

American Tubs

2.33(
3
)

American Tubs

2.33(
3
)
Customers say: Terrific value
13 years of experience

American Tubs designs and manufactures a complete line of premium quality Walk-In Bathtubs that are ideal for people with Limited Mobility, Seniors, Disabled and people with pain, arthritis, stress and other debilitating conditions.

American Tubs designs and manufactures a complete line of premium quality Walk-In Bathtubs that are ideal for people with Limited Mobility, Seniors, Disabled and people with pain, arthritis, stress and other debilitating conditions.

Bathtub Restoration questions, answered by experts

Even at the lowest setting, there’s always a risk that pressure washing might damage your shower or tub. Never use this technique if there’s pre-existing damage in your shower or tub, like peeling caulk, sealant, or cracked tiles. And skip this method entirely if there are any wood features present.

For a standard-sized bathtub with minor damage, it takes approximately 3 to 5 hours to refinish. It might take a bit longer if your bathtub refinishing contractor needs to fill in significant cracks or gouges. This is the same if you have a specialty tub, like an oversized bathtub—you can expect your pro to take a bit on the longer side.

Refinishing a bathtub takes about two to four hours, but let the surface set for another 24 to 48 hours before using it again. Once it's set, your tub should last for 10 years or more. Ventilating the bathroom during this time is key for safety. In comparison, it takes about four hours to install a new bathtub.

Properly maintained, resurfacing typically lasts 5-10 years. Factors like surface usage and exposure to chemicals affect longevity.

Before you begin caulking a shower, you’ll need to use a utility knife or solvent to remove the old caulk and inspect the area for mold. If needed, take appropriate steps to get rid of the mold, then wipe everything down with dish soap and warm water before letting it dry completely. Finally, surround the caulking area with two strips of blue painter’s tape—one above the joint where you’re caulking and another below it.

The Grover, SC homeowners’ guide to bathtub restorations

From average costs to expert advice, get all the answers you need to get your job done.