Top-rated deck repair pros.

Get matched with top deck repair pros in Roulette, PA

Enter your zip and get matched with up to 5 pros

Need a pro for your deck repair project in Roulette, PA?

Select your specific project to find the pro for you.

Find Deck repair pros in Roulette

Avatar for Complete Construction & Maintenance, Inc.
Complete Construction & Maintenance, Inc.
2.9(
12
)
Deck or Porch - RepairDeck or Porch - Repair - For Business

Serving Roulette, PA and surrounding areas

In business since 2012

Free estimates

Emergency services offered

"They were very pleasant. It was in a less than an ideal condition due to the heat. They were very knowledgeable of what was going on and everything went smoothly. They had a smile on their face by the time they were done with the work."
Photo 1
Photo 2
Photo 3
Photo 4
Photo 5

+20

Recommended by54%of homeowners
Showing 1-10 of 25
Deck Repair questions, answered by experts

When staining a deck, don’t skip surface prep, avoid staining damp or dirty boards, and don’t apply stain in extreme heat, cold, or wet conditions. Never overload the wood with a stain, as too much can cause tackiness or peeling. Also, don’t forget to test a small area first to ensure the color and finish look right.

Before installing any materials under the deck for removing moisture, you should perform some prep work on the ground. Work the dirt under the deck to create a grade away from the home. A grade of at least six inches for every 10 feet works well. Do not leave a gap between the dirt and the home’s foundation where water could pool. Once you or a contractor regrades the dirt under the deck, you then can add materials over the top.

Your deck may look or feel fuzzy after pressure washing because the high-pressure spray tears some wood fibers as it removes the outer layer of dead and discolored wood. This fuzzy effect is a normal part of the pressure-washing process and will go away on its own in a few weeks. You can opt to spot-sand your deck if you’d like to remove it more quickly.

Cutting the boards directly is one of the fastest ways to remove deck boards with hidden fasteners. Mark two parallel lines that are one-third of the total measurement on both ends and cut out the centerpiece. Then, remove the end of the board that doesn’t have a fastener. Finally, pry open the fastened side and pull it up to pop out the screw or access the fastener. This also allows you to salvage portions of boards for other projects.

Local building codes don’t specify the number of steps a deck can have before a railing is required, mainly because stair height varies widely. Most areas require decks 30 inches or higher to have a railing. While not exact, that roughly equates to four to seven steps.

The Roulette, PA homeowners’ guide to deck repair services

From average costs to expert advice, get all the answers you need to get your job done.