Get matched with top arborists in Jermyn, PA

Sudden oak death and oak wilt are different diseases. Oak wilt first shows up in tree leaves while sudden oak death affects the branches and trunk. However, as symptoms in both can overlap, it’s best to consult a professional arborist tree expert for a proper diagnosis and development of a treatment plan.

If executed correctly your tree should survive after being transplanted to a new spot. However, effective transplanting requires six months, careful root pruning, safe transport to the new location, and replanting in prime soil conditions. You’ll also need an appropriately sized root ball for a complete tree transplant. A good rule of thumb is that, for every inch in diameter, your tree’s root ball needs to be around 11 inches. So a tree with a diameter of six inches needs a root ball of approximately 66 inches.

Only trim palm trees as needed, which is usually about once per year. However, don't stick to that schedule if the palm tree doesn't need it. Avoid trimming palm trees when possible. It’s best to trim palm trees only when you notice a buildup of dead fronds. That said, leave the brown fronds during the dormant season because this organic matter helps protect the tree from the cooler weather.

There are several methods to hollow out a tree stump, and the best one depends on your tools, experience, and priorities. Common methods include using a chisel and hammer, a chainsaw, or burning.

• Chisel and Hammer: This is often considered the easiest approach for those with limited tools or experience, though it is the most time-consuming.

• Chainsaw: Using a chainsaw is the fastest method, but it comes with significant safety risks, especially for inexperienced users.

• Burning: This can be an effective method, but it is not recommended unless you can first drill holes into the stump. Without holes, the stump will be difficult to light and may not burn completely through.

A power drill with at least a ⅜-inch diameter bit can make the job quicker and easier, regardless of the primary method. While you can use a chisel or chainsaw without a drill, it will require more time and effort. Always wear protective goggles and thick gloves, as splinters are an inevitable risk.