Top-rated carpenters.

Get matched with top carpenters in Longtown, OK

Enter your zip and get matched with up to 5 pros

Need a pro for your carpentry project in Longtown, OK?

Select your specific project to find the pro for you.

TRUSTED BY LONGTOWN, OK HOMEOWNERS

  • Average homeowner rating star icon4.6
    Average homeowner rating
  • Verified reviews icon11
    Verified carpentry services reviews

Find Carpenters in Longtown

Avatar for TULSA CHRISTIAN BROS PAINTING, LLC
TULSA CHRISTIAN BROS PAINTING, LLC
4.0(
41
)

Serving Longtown, OK and surrounding areas

Approved

In business since 2008

Free estimates

Emergency services offered

"Price was a bit higher than some but in the middle overall. Had quotes from $1900-$5100. Project included pressure wash, scraping, some wood replacement/repair, caulking of all joints, painting with quality satin finish Sherwin Williams exterior. One color change for front door. Prep was done in one day. Wood repairs and 95% of painting done day two. Finish painting and clean up morning of day three. Great quality and workers. TCB coordinated schedule with gutter company so painting was done after gutters came down and then new gutters were installed after painting completed."
Project Photos
29 neighbors recently requested a quote
Recommended by82%of homeowners
Avatar for Sentri Homes
Sentri Homes
2.4(
27
)

Serving Longtown, OK and surrounding areas

Approved

In business since 2023

Free estimates

Emergency services offered

"Found Sentri on Angi. Jeanette and Violet were very pleasant and efficient in getting a contractor to me in the time frame needed. The contractor was excellent and the roof looks great! I would definitely work with them again if I had additional projects."
26 neighbors recently requested a quote
...
Showing 1-10 of 178
Carpentry questions, answered by experts

Most of the time, you’ll want to use screws on your subfloor rather than nails. Nails can actually weaken plywood, whereas screws can easily penetrate without damage. They also form a more secure connection because of their shape, preventing squeaky floors and tightly holding the subfloor in place. That said, some contractors do prefer nails depending on the type of floor covering because they allow for more flexibility.

Not all porch columns are load-bearing, though they can be. Some porch columns are simply decorative. There are ways to identify a load-bearing column, like looking for visible seams and a foundation. Also, check to see if the column directly enters the ground. In some porch installations, a contractor will excavate a hole to install a column into the earth along with a buried cement base for stability.

Yes, walls on the top floor can be load-bearing if stacked on the floor’s foundation.

There are approximately 5.33 board feet in a 2x4. You can use the board foot calculator in this article to easily find the answer. A 2x4 is 2 inches of thickness by 4 inches of width, so you need to find the length, with 8 feet being the most common. You’d use the calculator here to multiply 2 times 4 times 8, and then divide by 12, arriving at a total of 5.33 board feet. 

An A-frame home can be cheaper to build than a traditional house, but that is not always a given. Prices can be fairly similar in some cases, depending on the location, design, and necessary site preparation. Costs for an A-frame typically run between $100 to $200 per square foot, which is comparable to the cost of a traditional home. The cost of an A-frame can come in under those numbers if you opt for a prefabricated kit.

The Longtown, OK homeowners’ guide to carpentry services

From average costs to expert advice, get all the answers you need to get your job done.