Get matched with top garage pros in Copan, OK

No, there should not be a gap between your garage door and the floor. Gaps can make your garage less energy efficient, leading to higher energy bills. They also create an entry point for pests like rodents and insects, as well as rain and melted snow, which can lead to foundation damage or mold issues.

If you have a gap under your garage door, potential causes include an uneven garage floor or worn-out weather stripping. To fix it, you can try several solutions:

• Replace the weather stripping: The seal at the bottom of the door may need to be replaced.

• Adjust the garage door: You may be able to adjust the closing position on your garage door opener to eliminate the gap.

• Inspect the floor: If the concrete floor has shifted or is uneven, it may need to be repaired to create a level surface.

If these solutions do not resolve the issue, it is best to call a garage door repair specialist to inspect the door and floor.

Single and double garage doors have pros and cons, but it's all based on personal preference regarding which one is better for you. Two single garage doors give you more control over airflow entering your garage but double the system, which means double the upkeep cost. 

On the other hand, two-car double garage doors are more convenient but can stop you from leaving if a piece of hardware malfunctions.

If you have a garage heater that is 1,500 watts or more, it will need its own breaker. As a good rule of thumb, no appliance should exceed 1,500 watts per outlet for best outcomes. Consult a local garage heating service to determine the power needs for your outdoor or indoor space.

Yes, you can pressure wash epoxy floors, but you must take precautions to avoid damaging the surface. While most epoxy floors can be cleaned with a mop, you might choose to pressure wash if the floor is stained, has ground-in dirt, or is covered with mold or mildew. To do so safely, first soak any stains or dirty areas with a gentle cleanser. Use a lower pressure setting with a gentle nozzle, such as a green, white, or black tip, or a 45-degree angled tip. Keep the spray nozzle at least 18 inches away from the floor to protect the surface. Using a surface cleaner attachment or a rotary scrubber can also help prevent overspray. Be cautious if using a power washer that heats the water, as the combination of heat and pressure may be too powerful and could damage the epoxy coating.