Get matched with top sandblasting pros in Chickasha, OK

Sanding and pressure washing serve different purposes in deck maintenance, so one is not necessarily better than the other. Pressure washing is ideal for annual cleaning to remove dirt, grime, mold, and mildew. Sanding is a deeper restoration method used to smooth rough surfaces, remove an old finish, and prepare the wood for a new coat of stain or paint. The ideal process for refinishing a deck is to first clean it (with a power washer), then sand it, and finally apply the new stain or finish. While cleaning should be done annually, sanding and staining are typically needed only every one to three years.

Your pro will most likely bill you at an hourly rate of $50 to $80 per hour to sandblast a door due to its small size. This type of job won't take long, so if you have other surfaces that need cleaning, schedule those tasks at the same time to get your money's worth from your pro's visit.

Sandblasting is useful when you need to strip material off a hard surface. Common reasons to sandblast are to remove paint, rust, or get a surface ready for a new material. You aren’t limited to surfaces like walls either—you can sandblast rusted tools, bicycle frames, cement, bricks, and many others. If what you’re sandblasting is still structurally sound, sandblasting can be a fast and inexpensive way to revive the original material. 

Soda-blasting systems are slightly more expensive than sandblasting systems. To soda blast, you’ll need to spend a few hundred dollars for a blast hose and nozzle, a compressed air supply, a blast generator, a moisture decontamination system, and sodium bicarbonate media, a recurring cost because the powder is not reusable. To start with sandblasting, you will need to spend upwards of $30 for a blast pot, a blast gun, an air compressor, and sandblasting media, many of which are recyclable—further reducing the cost. The total cost for either will depend on the size of the system.