Top-rated water heater pros.

Get matched with top water heater pros in Beaver, OK

Enter your zip and get matched with up to 5 pros

Need a pro for your water heater service project in Beaver, OK?

Select your specific project to find the pro for you.

Find Water heater pros in Beaver

Avatar for American Home Shield – Home Warranty
American Home Shield – Home Warranty
3.5(
5,688
)
Solar Water Heater System - InstallTankless Water Heater - InstallTankless Water Heater - Install - For Business+6 more

Serving Beaver, OK and surrounding areas

In business since 1971

Credit card accepted

"We pay yearly but we have this is included with our rental property. They are pretty good on most things. We had a hot water heater replaced and they did an excellent job on that. They are very quick on their response. They dont come out here. It is all done on the internet.  I just like the idea that one time service charge is so much better than trying to hiring someone to come in. It is more about convenience. It pays for itself."
Additional Photos
Additional Photos
Additional Photos
Additional Photos
Additional Photos

+2

Recommended by65%of homeowners
Avatar for Roger Allen Restorations & Homes
Roger Allen Restorations & Homes
4.3(
19
)
Solar Water Heater System - InstallTankless Water Heater - InstallTankless Water Heater - Install - For Business+6 more

Serving Beaver, OK and surrounding areas

In business since 1947

Free estimates

"I recently purchased a Fannie Mae foreclosure, a house with nice potential but quite a mess to get started with.  I contacted a couple of names from Angie's List and Roger Allen was so professional from the get go (good guy too), I went with him pretty quickly.  He was able to get an estimate together and to my lender soon after I had asked.  I'm not an expert on pricing but his numbers were consistent with the other I had received and ended up being accurate by the time everything was done.  On small jobs that is easy, on the mess that was my house, quite a challenge.  We had problems all around from an iffy septic system, siding peeling away, no hot water heaters, ancient electrical boxes, decor from a generation long past, leaks in the shower/master bath, carpeting that had seen much better days, etc.  He was able to take care of everything inside of my budget without any glaring omissions.  Even when my wife picked out expensive paints, he was able to take care of the overage.  Roger and his people have been great, I'll be using him for any future fix-it jobs in the future for sure."
A small portion of a custom kitchen
Another kitchen with glass and enviroglass countertop
A million dollar foyer...
Installed Travertien after reinstalling a new concrete shower pan
The final finish

+2

Recommended by72%of homeowners
Avatar for Skippie's Services
Skippie's Services
New to Angi
Water Heater - Install or Replace

Serving Beaver, OK and surrounding areas

In business since 2022

Small jobs welcome

Credit card accepted

We pride our company on reliability, great communication, integrity and quality work. We are experts in our electrical and computing and will do our best to keep you as educated as we can on your particular task or project. We look forward to working with you.\n

Response time2 days
Water Heaters questions, answered by experts

A single shower consumes an average of over 17 gallons, while brushing your teeth with the water running uses up to four unnecessary gallons. Watering the lawn spreads hundreds of gallons of water across the yard each time. Limiting water usage in these areas can significantly cut down your water bill.

Yes, most municipalities have codes that require water heaters to have pans. A pan is necessary when a water heater or hot water storage tank is installed in an area where water leakage could cause damage, such as an attic, second floor, or finished basement. Tankless water heaters are not required to have a pan since there is no storage tank.

Most standard residential water heaters, which are typically around 40 gallons and use 240 volts and between 3,500 and 5,500 watts, require a 30-amp, two-pole circuit breaker. For smaller, point-of-use water heaters using 120 volts and between 1,500 and 3,000 watts, a 30-amp breaker is also often adequate. However, some models may have different needs; units that use more watts than average may require a 40-amp breaker, while smaller units might only need a 20-amp breaker. Newer, tankless, or more energy-efficient models can also require a higher amperage. Having the correct breaker size is crucial for safe and efficient operation, so it's best to consult a licensed electrician to determine the specific needs of your water heater.

Unless they are connected to the same system, boilers and water heaters will both need their own expansion tanks. The only case they wouldn’t have separate expansion tanks is if the boiler is pulling double duty and managing a heating system while also supplying hot water for a home. In which case, you may not need a hot water heater.

No, you’ll need to drain the tank before changing a water heater element, as the water heater element sticks through the side of the tank and uses a gasket to prevent water from pouring out. However, you don’t always need to drain it completely. If you’re only replacing the upper heating element, you can drain the tank until the water line is below the element. If you’re replacing the lower element, you’ll need to drain the whole thing.

The Beaver, OK homeowners’ guide to water heater services

From average costs to expert advice, get all the answers you need to get your job done.