Get matched with top deck maintenance specialists in Waddington, NY

Putting lattice under a deck will create a polished look that allows for air ventilation. You can also store items underneath as the lattice provides privacy and protection from the weather. You can also put lattice under a porch to create a polished look in the front of your house.

No, you don’t need a permit to repair and replace a few boards on an existing deck. However, if you’re making structural changes to the deck or tearing down the old one and building a new one, you will likely need a permit. Check with your local municipality for the regulations and rules in your area, or ask a local contractor who builds decks for advice.

Cutting the boards directly is one of the fastest ways to remove deck boards with hidden fasteners. Mark two parallel lines that are one-third of the total measurement on both ends and cut out the centerpiece. Then, remove the end of the board that doesn’t have a fastener. Finally, pry open the fastened side and pull it up to pop out the screw or access the fastener. This also allows you to salvage portions of boards for other projects.

Building codes for deck railings can vary by location, so it's important to consult your local regulations before construction. Generally, a guardrail is required for any deck that is more than 30 inches above the ground.

For residential properties, the standard minimum height for a deck railing is 36 inches. However, some states and municipalities have stricter requirements; for example, California and Washington mandate railings that are at least 42 inches high. Therefore, a 42-inch railing is not considered too high and may be required in your area or chosen voluntarily for additional safety.

In addition to height requirements, codes also specify other safety features, such as the maximum spacing between balusters to ensure they are close enough to prevent a child from squeezing through.