Get matched with top dishwasher installation pros in Laurel, NY

To clean an old dishwasher without a filter, start by removing the bottom rack to access the drain area. Use a damp cloth or sponge to wipe down the interior, paying special attention to the corners and crevices where food particles and debris can build up. Pour a cup of white vinegar into a dishwasher-safe bowl and place it on the top rack, then run a hot water cycle to help break down grease and grime. After the cycle, sprinkle a cup of baking soda across the bottom of the dishwasher and run a short hot water cycle to deodorize and further clean the interior. 

Several signs can tip you off to a clogged dishwasher drain. At first, you may notice that it’s taking longer than usual for the dishwasher to drain, or you may hear gurgling sounds during the draining part of the cycle. You might also notice water backing up into your sink or excess food at the bottom of the dishwasher after a load. The most obvious sign, though, is seeing standing water at the bottom of your dishwasher after the cycle has finished.

There are some dishwasher care tips to extend its longevity and keep your dishes sparkling. Not overloading your dishwasher is key to letting water and soap move freely through the unit. Too much soap can stress your dishwasher unnecessarily, causing it to break down sooner. 

Cleaning your dishwasher is essential for its performance, so every three to six months, put two cups of white vinegar in a dishwasher-safe cup on the top rack and run a complete cycle. When done, place ¼ cup of baking soda inside and run a short cycle to eliminate any lingering odors.

You should follow the instructions listed on the detergent packaging and in your dishwasher user manual. Often, this means inserting the tablet or pod into the detergent dispenser (and not in the bottom of the dishwasher). If you put the pod anywhere else, it might dissolve too early in the cycle and fail to clean your dishes properly.