Get matched with top concrete driveway pros in Denmark, NY

Yes, you can pressure wash with just water. The force of the water alone is often enough to remove dirt, grime, and debris from many surfaces. However, for tougher stains like grease, mildew, or algae, adding a detergent or cleaning solution can enhance the cleaning power. Be sure to use the appropriate nozzle and pressure settings for the surface to achieve the best results without causing damage.

The ideal PSI (pounds per square inch) for a pressure washer depends on the surface you are cleaning. For general home use, a pressure washer with a range of 2,000 to 3,000 PSI is recommended and powerful enough for most residential projects.

The specific PSI you should use varies by task:

• High-Pressure Tasks (2,500-3,000 PSI): Tough materials like concrete, stone, masonry, and brick can handle higher pressures. This is suitable for removing stubborn stains from driveways or cleaning graffiti.

• Low-Pressure Tasks (around 600-1,300 PSI): Softer surfaces require a gentler touch to avoid damage. Use a low PSI setting for cleaning wood decks (especially softwoods like pine and cedar), vinyl siding, outdoor furniture, and stucco.

For best results, choose the right nozzle for your surface, such as a 15-degree nozzle for siding or a surface cleaner attachment for driveways. Using an extendable wand can also make the work easier and more ergonomic.

There’s no legal requirement that states that you need rebar in a concrete driveway, but since the slab will be supporting heavy vehicle loads, it’s always a good idea to pay a bit more for rebar reinforcement. Your driveway will be much more likely to crack if you don’t reinforce it with rebar. Driveways that need to support commercial vehicles or provide parking for multiple vehicles at once should always include rebar reinforcement. If you’re pouring concrete over asphalt or pouring concrete over an existing slab, you may not have enough depth for rebar, meaning an increased risk of cracking.

Yes, you can use a mixture of 1 tablespoon of bleach and a gallon of warm water to clean stubborn stains from brick. Do not use bleach without diluting it in water. Undiluted bleach may cause discoloration. You can use either Oxygen bleach such as OxiClean or chlorine bleach. Always wear protective gloves and eye protection when handling bleach.