Get matched with top countertop and backsplash pros in Chenango Forks, NY

Yes, Corian® and other solid surface countertops can be cut with standard woodworking tools like a circular saw or a jigsaw, but using the correct blade is crucial for the best results.

The recommended blade is a tungsten carbide-tipped blade, often called a solid-surface planer or triple chip grind blade. This type of blade is hard enough to cut through the material effectively. For a jigsaw, a fine-tooth down-cutting blade should be used.

It is important to note that a diamond blade is not necessary. Diamond blades are designed for harder materials like natural stone, concrete, or brick, and Corian is not a natural stone.

Using blades designed for wood is not recommended as they can cause microfractures that weaken the countertop's edges. While a tungsten carbide blade provides a much cleaner cut, the resulting edge will still be rough and must be sanded and smoothed to prevent microfractures from developing over time.

Yes, you can install a new layer of laminate over an existing laminate countertop, which can save you time and money while updating its appearance. The process is similar to installing laminate directly onto particle board. First, clean the existing countertop thoroughly. Next, fill and sand any cracks or damaged areas. Then, you'll need to sand or scratch up the entire surface to help the contact cement or glue adhere properly. After applying the adhesive, you can install the new laminate layer on top. If you're looking for other ways to improve your existing laminate countertops, you could also consider painting them or applying an epoxy finish.

You can cut countertops without chipping by using your saw correctly and having a new fine-toothed blade. You can also put masking tape on the front of the countertop material across the cut line and cut from front to back. However, it is very hard to cut countertops without chipping them, especially if they are made of stone or more fragile materials like laminate. The best advice is to know how to use the equipment, use the correct cutting method for the material, cut from back to front, move slowly, and practice on scrap material first.

Epoxy is typically more affordable than granite, especially if you’re choosing a high-end slab. Most granite countertops cost $75 to $145 per square foot to install, with high-end varieties topping $185 per square foot. 

In contrast, epoxy countertops cost $50 to $150 per square foot to install. The material costs for epoxy are significantly lower than granite, but installation costs can be higher. Rather than simply cutting granite countertops to size before installation, your contractor will need to carefully pour the epoxy over an existing surface.