Get matched with top concrete mudjacking pros in Spring Creek, NV

Polyjacking and mudjacking can both be good solutions to sinking concrete, depending on your situation. Polyjacking, which uses expanding polyurethane foam to lift concrete, is a better option than mudjacking because the foam weighs less and won’t contribute to additional sinking. Polyjacking can be a suitable solution for any sinking concrete slab, while mudjacking is normally only a good option for non-structural concrete, like sidewalks, patios, pool decks, and concrete driveways. However, polyjacking costs much more—as much as $25 per square foot, compared to the maximum of $6 per square foot you’d pay for mudjacking.

Generally speaking, push piers—or steel piers—are the best option for underpinning, as they reach down to solid bedrock to find support for your foundation rather than relying on soil, which could be subject to the same issues as the soil directly below your foundation. However, the best underpinning method for your home depends on your location, how far down the bedrock is, and the type of soil in your area. Helical piers are usually the best option for sandy soil or in areas where the bedrock is too deep to use steel piers.

Mudjacking normally takes between one to three days to dry completely. The larger the project area, the more time it will take to dry. You should not walk on the concrete or place furniture or vehicles on the lifted concrete until it’s completely cured, which a pro can help determine. If you’re polyjacking instead, the polyurethane foam can take just a few minutes to dry, but wait an hour to be sure.

Mudjacking is your best bet for leveling concrete on a tighter budget. It’s less expensive than foam or grout mixture. For smaller, surface-level issues, you could also use a self-leveling compound, which creates an even surface over existing concrete—it’s a budget-friendly option suitable for DIY enthusiasts.