Top-rated well and pump technicians.

Get matched with top well and pump technicians in Logan, NM

Enter your zip and get matched with up to 5 pros

Need a pro for your well and pump service project in Logan, NM?

Select your specific project to find the pro for you.

Find Well and pump technicians in Logan

Avatar for American Home Shield – Home Warranty
American Home Shield – Home Warranty
3.5(
5,688
)
Well Pump - Install or ReplaceWell Pump - Repair or Service

Serving Logan, NM and surrounding areas

In business since 1971

Credit card accepted

"Well, the first time the replacement was ordered it was the wrong one, which of course, delayed the installation a week. When it was finally installed I had to pay an additional $850 for code upgrades. This I was not informed of by Home Shield. Then we noticed that there was water on the garage floor and found that the pipe coming in from the wall was leaking at the wall so had to call the plumbing company back out to fix it. They first tried to say it was not their fault but since there wasn't a leak before they installed they did fix it. I have used Home Shield a few times before and never had a problem. Some of the companies they use are not the best so you have to research them before you commit. I have found HS service to be good if you do your homework. At the end of the day I was without hot water for almost 3 weeks but it was do to the plumbing company they sent out."
Additional Photos
Additional Photos
Additional Photos
Additional Photos
Additional Photos

+2

Recommended by65%of homeowners
Wells and Pumps questions, answered by experts

Though sprinkler systems can have varying issues, there are a few common ways to know if the cause is your pump. Signs include cracking or visible damage, leaking from the pump, a pump that won’t turn on, and loud noises coming from your pump. Low or irregular pressure could also point to a pump problem, but there are other causes.

The pressure in a well pressure tank should be set 2 to 3 PSI below the pump's cut-on pressure. The cut-on pressure is the lower number in the pressure setting (e.g., the '30' in 30/50 PSI) and is the point at which the pump starts. The cut-out pressure is the higher number, where the pump stops.

For example:

  • If your pressure switch is set to 30/50 PSI, the tank pressure should be 27-28 PSI.

  • If your pressure switch is set to 40/60 PSI, the tank pressure should be 38 PSI.

Common pressure settings for household applications include 20/40, 30/50, and 40/60 PSI. The difference between the cut-on and cut-out pressure is typically 20 PSI.

A professional well inspection takes between one and three hours. This includes the time it takes for the inspector to visually check the condition of your well, test its equipment, and collect water for testing. After the pro sends the water samples to the lab, you can expect to receive the results in three to 10 days.

A well pressure tank is located between the well and the well pump, and it stores your water under pressure so that the well pump can eventually do its job. The well pump is activated whenever you turn a faucet on—it pulls the water from the tank into your home. Both are vital parts of a complete well water system.

With regular servicing and general upkeep, both a well pump and pressure tank can last for years. The average lifespan of a well pump is around eight to 15 years. A well pressure tank can last from seven to 10 years. How long a well pump and pressure tank lasts also depends on a variety of factors such as type, size, material, and brand.

The Logan, NM homeowners’ guide to well and pump services

From average costs to expert advice, get all the answers you need to get your job done.