Get matched with top roofers in Kearny, NJ

Skipping the installation of a drip edge or gutter apron can lead to significant water damage. Without this component, water is more likely to seep under roofing materials or leak behind gutters, damaging the fascia, soffits, siding, and even the interior of your home, such as the attic. Over time, this moisture can cause rot, mold, and deterioration. In colder climates, a missing drip edge also increases the risk of ice dams, which can lead to expensive repairs. A drip edge is an essential part of a roof's drainage system, and some local building codes may even require its installation to protect the home from water damage.

Furring strips (also called wood stripping) are not always necessary for a metal roof installation, but they are highly recommended and may be required by local building codes or the roofing manufacturer's specifications. There are several key reasons to use them:

• Energy Efficiency: Furring strips, made of wood or metal, create an air gap between the metal panels and the roof deck. This acts as a thermal break, reducing heat transfer into your home and improving overall energy efficiency.

• Moisture and Condensation Control: The air gap allows for better airflow, which helps prevent moisture buildup and condensation under the metal panels.

• Structural Support: They provide a solid, even frame to which you can attach the metal roofing panels.

It is especially important to use furring strips when installing a metal roof over existing shingles. Without them, the roof surface can be uneven, and you will experience greater solar heat gain.

TPO roofing can last anywhere from 15 to 30 years, or an average of 22 years, but you can extend its life expectancy through proper roof maintenance. For the best chance at realizing the longest life span possible, keep tree branches trimmed so they’re not in contact with the roofing material. Inspect your roof regularly and repair any damage immediately.

A roof's ability to handle snow depends on its strength and the snow's weight, as wet snow is much heavier than dry, fluffy snow. While designs in snowy regions often allow for 35 to 50 pounds per square foot, a general guideline is that a typical roof can withstand about four feet of fresh snow, two feet of packed snow, or just one inch of ice. Factors like the roof's age, slope, and support structure also affect its capacity; newer, sloped roofs generally hold more weight than older, flat ones. Ice and ice dams add significant, dangerous weight. Because capacity varies, it is best to contact a professional roofing contractor or the original builder to determine the maximum snow load for your specific home.