Top-rated masons.

Get matched with top masons in Lyman, NH

Enter your zip and get matched with up to 5 pros

Need a pro for your masonry work project in Lyman, NH?

Select your specific project to find the pro for you.

Find Masons in Lyman

Avatar for Northern Basement Systems
Northern Basement Systems
4.6(
21
)
Foundation, Basement or Crawlspace - Waterproofing / EncapsulationConcrete Foundation - RepairBasement Drainage Channels - Install+3 more

Serving Lyman, NH and surrounding areas

Approved

In business since 2010

Free estimates

Warranties offered

"Northern basements was able to fit us in quickly, pulled our crooked cement wall back in-place and sealed the wall to prevent future leaks.  The work was timely, communication was friendly and detailed, and price was as to be expected for the large amount of work that needed to be done.  We are very pleased with the whole process as well as the results.
"
Additional Photos
Additional Photos
Additional Photos
Additional Photos
Additional Photos

+25

Response time1 day
7 neighbors recently requested a quote
Recommended by88%of homeowners
Avatar for Your Chimney Doctor
Your Chimney Doctor
4.9(
16
)
Brick or Stone - Tuck-pointingBrick or Stone - Tuckpointing - For Business

Serving Lyman, NH and surrounding areas

Approved

In business since 2021

Free estimates

Emergency services offered

"Our chimney needed to be raised and brought up to current code, and the solution was handled the right way from start to finish. The chimney was lifted to the proper height and securely strapped to meet structural and safety requirements. Everything was measured, reinforced, and stabilized so it’s not just compliant, but solid moving forward. The work was well planned, clearly explained, and executed with attention to both function and appearance. It’s reassuring knowing the chimney now meets code and is properly supported."
Chimney Doctor
Mailbox rebuild
Restack & Rebuild
Garage Rebuild
Full grind & repoint

+8

11 neighbors recently requested a quote
Avatar for HANDY ANDY SPECIALTY SERVICES LLC
HANDY ANDY SPECIALTY SERVICES LLC
4.9(
10
)
Brick or Stone - Tuck-pointing

Serving Lyman, NH and surrounding areas

Approved

In business since 2024

Free estimates

Small jobs welcome

"I had them do a cleaning and inspection of my chimney and they found damages to the brickwork and the top of the chimney. They installed a new cap and their cost was so reasonable. All their work is guaranteed as well, which is reassuring. They were clean, efficient and courteous. I would highly recommend Handy Andy and in fact they are doing an estimate for my neighbor to whom I recommended them to."
11 neighbors recently requested a quote
...
Showing 1-10 of 84
Masonry questions, answered by experts

You may not need a hammer drill if you’re planning on drilling one or two very small diameter holes in brick. For holes with a diameter of 3/16-inch or less, a regular drill with a masonry bit can do the job. However, the bit will heat up quickly, and the process will take significantly longer than with a hammer drill. Prepare to cool your drill bit down in a bucket of water more often.

Initially, brick staining is not cheaper than painting. However, while it has a higher up-front cost, it may be more cost-effective in the long run. Brick stain can last for 20 years or longer, compared to paint, which usually starts to peel away in three to five years.

You will repoint over a fraction of the old mortar, but you should scrape away 1/2 to 1 inch of mortar from the joints before repointing. Otherwise, the repointing is only masking the weakened mortar instead of actually replacing it, which could put your chimney at risk of bigger, more expensive damages later on.

It’s called cobblestone because it’s made of stones that are “cobbed” together. A cob is a term that refers to rounded lumps. Originally, cobblestone streets were made from pebbles and stones gathered from riverbeds that had been rounded over time by the passage of water. The term has nothing to do with a cobbler, which is the term for someone who makes and fixes shoes.

No, using a power sander on brick is not recommended because the force of the sander can destroy brick's fragile outer layer. Even using sandpaper on brick is discouraged because of the damage its abrasiveness can cause.

The Lyman, NH homeowners’ guide to masonry services

From average costs to expert advice, get all the answers you need to get your job done.