Best masons near Lempster, NH

Two types of masonry are veneer masonry and solid masonry. Veneer masonry is thin brick or stone material attached to the face of a building. With veneer masonry, the walls support the weight of the masonry products rather than the masonry being built on a concrete footing. Solid masonry is a wall or other brick or stone structure built on a concrete footing, and the masonry supports itself.

While painting can certainly change the look of a chimney, you should think twice about giving your brick chimney the old landlord special.

Painting brick is porous, meaning it’s full of tiny holes that can soak up moisture. Those holes also allow it to dry, though. So, when you paint it, you trap any moisture inside, providing an opportunity for mold, mildew, and water damage.

Paint also shows wear faster than naked brick. This means that once you paint a brick surface, you’ll have to keep painting it to maintain a clean look. A paint job is also harder to undo on brick because of its porous nature. Once you paint it, it’s hard to go back without some serious power washing—another added cost.

The best tool for drilling into brick or mortar is a rotary hammer drill which is a large hammer drill with low rotation speed and high torque. Regular drills with a hammer function are also excellent tools for drilling into brick when the diameter of the hole is 1/2 inch or less. It might be possible to drill into brick with a standard drill if you’re only drilling a very small hole, but note that masonry work will put a lot of wear on a standard drill, and the tool may not be strong enough to get through brick.

No, it’s not recommended to attach shutters to brick without drilling. Brick is dense and built to last, so adhesives and shortcut methods don’t usually cut it. Even heavy-duty glue struggles to hold up over time—especially against wind, moisture, and temperature changes. Most no-drill options are made for materials like vinyl or wood, not solid masonry. Skipping the drill might seem easier, but it puts your shutters—and anything below them—at risk. For a secure, lasting install, drilling is the way to go. It takes more effort up front, but the result is safer and more reliable.