Top-rated tub and shower conversion pros.

Get matched with top tub and shower conversion pros in Stuart, NE

Enter your zip and get matched with up to 5 pros

Need a pro for your tub and shower conversion project in Stuart, NE?

Select your specific project to find the pro for you.

Find Tub and shower conversion pros in Stuart

Avatar for Bath Fitter
Bath Fitter
3.9(
18
)
Bathtub Liner or Shower Surround - Install or ReplaceShower Install or ReplaceBathtub Install or Replace

Serving Stuart, NE and surrounding areas

Approved

In business since 1977

Free estimates

Warranties offered

"Always answered or talked about my concerns without transferring me to multiple people. Knowledgeable, explained each step, installer was immaculate with cleanup. No complaints from us"
Croft_1
Croft_2
Croft_3
Croft_4
Swierzewski_1

+15

Response time1 day
188 neighbors recently requested a quote
Recommended by78%of homeowners
Avatar for Jill Seidner Interior Design
Jill Seidner Interior Design
3.5(
89
)
Bathroom - RemodelBathroom - Remodel - For BusinessBathtub Install or Replace+3 more

Serving Stuart, NE and surrounding areas

In business since 2006

Credit card accepted

"Once I sent her all the measurements, it took her a little while to get the options back to me.  Overall, they're good designs.  However, they're very simplistic and give general ideas for space planning.  I was hoping to have a better idea for sizes of furniture for the space and some variations on staging.  
Jill was very responsive when I did have a question.  I'm not sure how helpful it is to have a virtual design done.  If we lived in similar cities, I'd probably use her again for help with additional designs.
"
Recommended by55%of homeowners
Roy Varilek
New to Angi
Bathroom - Remodel

Serving Stuart, NE and surrounding areas

In business since 2020

Free estimates

Emergency services offered

Roy Varilek is committed to excellence in every aspect of our business. We uphold a standard of integrity bound by fairness, honesty, and personal responsibility. Our distinction is the quality of service we bring to our customers. Accurate knowledge of our trade combined with ability is what makes us true professionals. Above all, we are watchful of our customers' interests, and make their concerns the basis of our business.

Tub Shower Conversion questions, answered by experts

The amount of space needed depends on the size of the shower. For the standard 32-by-32-inch walk-in shower, you’ll need about 50 square inches. The International Residential Code requires a minimum of 24 inches of space in front of a walk-in shower’s entrance. That said, the National Kitchen & Bath Association recommends 30 inches of clearance, which is a bit more comfortable for most people. 

Ideally, you’ll have enough room to open your doors and cabinets without interfering with your shower. This may not be possible in a smaller bathroom.

Yes, a toilet, sink, and shower can share the same vent. This is a common installation method that can simplify plumbing and save space. However, there are important considerations. The vent and associated plumbing must be large enough to handle the demands of all fixtures without compromising the vent's effectiveness. Additionally, the toilet should always be located downstream of all other fixtures. Because requirements can vary and space might be limited, it is essential to check your local building and plumbing codes and consult with a qualified plumber to ensure the installation is done correctly.

Typically, a wet room costs more than a walk-in shower. Installing a walk-in shower costs an average of $6,700, but this price can go up for a customized shower with high-end materials. By comparison, the average price for building a wet room is $9,000, with the low end of this project hovering around $2,000 and going up to around $30,000 on the high end. Because a wet room often includes renovating the whole space, you’ll spend more on this project.

Most shower pans can be cut to size, including those made from mortar, polystyrene, tile (and the under-tile ABS lining), and even solid surfaces. The only common shower pan material you cannot easily cut to size is cast iron because it is heavy, difficult to cut, and prone to rust once the protective enamel has been removed.

Yes, it would be best if you waterproofed your shower walls before tiling. The cement backing board behind the tile is not waterproof; it’s only water-resistant. On top of your tile backing board, be sure to use a waterproof shower membrane before you start installing your shower tiles.

The Stuart, NE homeowners’ guide to tub and shower conversion services

From average costs to expert advice, get all the answers you need to get your job done.