Get matched with top bathtub restoration pros in Saint Paul, NE

Bathtub refinishing costs an average of $460 and includes removing the finish, sanding or acid etching the surface, priming it, and applying an epoxy coating. After the coating cures, the bathtub should look as good as new, and the finish should last between seven and 10 years. Because bathtub refinishing requires hazardous chemicals, you should call a bathtub refinisher to do the job.

Before you begin caulking a shower, you’ll need to use a utility knife or solvent to remove the old caulk and inspect the area for mold. If needed, take appropriate steps to get rid of the mold, then wipe everything down with dish soap and warm water before letting it dry completely. Finally, surround the caulking area with two strips of blue painter’s tape—one above the joint where you’re caulking and another below it.

The cost to refinish a bathtub is $490 for most homeowners. However, this cost can range from $200 to $1,000 or more, depending on your tub's material and condition. 

For example, enamel and cast-iron bathtubs are pretty straightforward to refinish, costing between $350 and $600. However, if you have an antique claw-foot tub, you can expect to pay between $500 and $1,200 for refinishing costs due to the care and complexity needed.

Resurfacing a bathtub is less expensive than replacing one. Resurfacing a tub costs about $330 to $630, depending on the material, while replacing a tub costs an average of $4,150. But remember that resurfacing is a temporary solution for a worn-out tub, and you may need to refinish a tub every few years to keep it looking new.