Get matched with top drain cleaners in Red Cloud, NE

You should not attempt to snake your sewer yourself. Accessing and snaking your sewer requires heavy-duty equipment, and while renting is possible, misusing it can damage your sewer main and leave you with very expensive repair costs, not to mention potential environmental issues and severe water damage. Accessing your sewer also exposes you to hazardous sewer gasses, and failing to seal the sewer properly after work can be very dangerous. It’s always best to hire a professional sewer cleaner near you to handle this type of work.

On average, a plumber will take 30 minutes to two hours to clear a clogged drain. If the clog is located close to the drain or an access point and isn’t severe, the project will take about half an hour. If the clog is deep within your plumbing system or is a severe blockage, it can take two or more hours to remove the clog. For this reason, main line clogs tend to take longer, usually between two and three hours.

If you want to avoid using a snake to unclog a drain, or if you don’t have one, try vinegar and baking soda. Pour 1 cup of baking soda down the drain, followed by 1 cup of white vinegar. Wait for 15 minutes, and then run hot water (but not boiling water) down the drain to see if the clog is clear. Repeat multiple times as needed.

It is okay to use a drain auger on a toilet, just make sure you are using the correct tip size. The auger is a plumbing snake with a protective sleeve to protect the porcelain toilet bowl from getting scratched. Using too large of an auger can cause the snake to loop back and damage the inside of the drain and plumbing.