Get matched with top epoxy flooring pros in Pierce, NE

If your concrete stains are green in color, it indicates the presence of mold or algae—which you should address right away. If left unattended, mold will spread to other areas throughout the home. However, be careful not to disturb mold on indoor concrete surfaces and work with a local mold remediation specialist for specialized care. Once free from mold and algae, seal your concrete to eliminate pores and gaps.

The amount of paint needed to cover a two-car garage floor depends on the surface area and the product's coverage rate. On average, a standard two-car garage floor measures 400 to 500 square feet. Coverage ranges from 100 to 200 square feet per gallon for epoxy paint, depending on the product and application method. After some quick math, you may need 2 to 5 gallons of epoxy paint with two coats to cover a two-car garage floor. 

Unlike paint, concrete stain won’t peel off. Instead, the color absorbs into the surface of this porous building material. While it doesn’t peel, the stain only penetrates the top layer of concrete, and as the top of the concrete eventually wears away, so will the stain. However, this process is much slower than paint peeling, especially on low-traffic surfaces.

Yes, you can seal old or existing concrete, but proper preparation is crucial. The concrete surface must be clean, dry, and free of any incompatible old sealant. To check if an old sealer is present, drip a few drops of water onto the surface; if the water is absorbed in under five minutes, it's ready to be resealed. If you plan to use the same type of sealer that was previously applied, you may not need to remove the old layer. However, if you are using a different type of sealer, the old one must be completely removed. Before applying the new sealer, thoroughly clean the concrete and repair or fill any cracks to ensure a smooth, well-prepared surface.