Get matched with top furniture refinishers in Palmer, NE

A cloudy film on top of a wooden surface usually means either the incorrect cleaner was used or there is polish buildup. You’ll need to start over again and remove the surface cleaner with a damp rag and some water and dish soap. Be careful not to leave the wood surface wet as this could cause water damage.

When browsing the hardware store, you may wonder about wood putty versus wood filler. Wood putty is made with plastic adhesive, whereas wood filler is made from sawdust or wood products. 

The main difference is that people use wood filler to fix the interior portions of wood. Wood putty contains chemicals that could damage the inside of wood, so it's best for exterior sections. If the crack or hole goes into the middle of the lumber, it's the right product for the job.

The difference between resurfacing and refinishing is that refinishing only works on solid surfaces that are in good condition, whereas resurfacing will restore a cracked or worn surface to its original, blemish-free state. Refinishing will leave you with a smooth and glossy surface you can’t get from resurfacing alone. If that’s the look you’re going for, contact a local concrete finishing contractor to achieve it.

If your wood furniture is sticky after already cleaning it, it’s likely from using too many polishes or waxes. You’ll need to remove some of the excess wax with a cloth and warm water mixed with dish soap. You can then reapply the wax or polish afterwards, but try to use a much smaller amount and wipe away any excess.