Top-rated floor polishers.

Get matched with top floor polishers in Kimball, NE

Enter your zip and get matched with up to 5 pros

Need a pro for your floor polishing project in Kimball, NE?

Select your specific project to find the pro for you.

Verified Reviews for Floor Polishing pros in Kimball, NE

*The Angi rating for Floor Polishing companies in Kimball, NE is a rating based on verified reviews from our community of homeowners who have used these pros to meet their Floor Polishing needs.

*The HomeAdvisor rating for Floor Polishing companies in Kimball, NE is a rating based on verified reviews from our community of homeowners who have used these pros to meet their Floor Polishing needs.

Last update on December 14, 2023

Find Floor polishers in Kimball

Floor Polishers questions, answered by experts

If you have waxed floors or floors with a penetrating stain or oil, you can shine them up with some more wax and a cloth or floor buffer. After cleaning the floor thoroughly, apply wax to the floor in small sections and use a clean, dry cloth or towel to buff it until it shines. You can also use an electric polisher, which is especially handy for large floors.

Costs depend on floor type, area size, and additional services like waxing or sealing.

The answer to this question depends on how large the room is and how much experience you have stripping and waxing floors. It will take at least 24 hours to strip the floors, then you must allow time for drying, waxing, waiting for them to cure, and, finally, buffing them. Since you likely will not be working for the full 24 hours, it is safe to say that this is a two- or three-day job.

Yes, you can mop hardwood floors with a damp flat or string mop as long as it is not soaking wet. Always avoid leaving standing water or fully soaking your hardwood floors, even if they are properly finished. A slightly wet mop, with or without cleaning solutions, will not damage the wood.

Yes, but with caution. A floor grinder is intended to level and polish concrete, so it is a very powerful tool. To remove paint, the floor grinder should be set to 35 square feet per minute or less to minimize the pressure without the use of pocket weights. You might need to go over the surface two times to get any paint that has sunk into the concrete’s pores.

The Kimball, NE homeowners’ guide to floor polishing services

From average costs to expert advice, get all the answers you need to get your job done.

See all articles