Get matched with top bathtub restoration pros in Kimball, NE

Most homeowners need to wait at least two days, sometimes three, to use their bathtub following the reglazing process. That’s the normal length of time it takes for epoxy resin to cure. There are quick-dry epoxy kits available that cure in 12 hours, though. To ensure that the epoxy dries properly, try to ventilate the bathroom as well as you can.

Before you begin caulking a shower, you’ll need to use a utility knife or solvent to remove the old caulk and inspect the area for mold. If needed, take appropriate steps to get rid of the mold, then wipe everything down with dish soap and warm water before letting it dry completely. Finally, surround the caulking area with two strips of blue painter’s tape—one above the joint where you’re caulking and another below it.

If you don’t caulk your bathtub, then there won’t be a watertight seal between your bathtub and the wall tile surrounding it. As a result, water can seep into the wall and the floor and cause the perfect breeding grounds for mold and mildew. Not only does this require costly repairs, but mold can be harmful to those breathing it. 

You can resurface or reglaze your bathtub, and it’s faster and less expensive than replacing a bathtub. Plus, replacing a bathtub is an extensive and intrusive process that requires wall repairs. Refinishing is an excellent option if the old one is in good working condition.

There are also options to install a bathtub liner over your existing tub. However, if you’re seeking a new bathtub with new features, you’ll likely want to replace your tub.