Get matched with top wall repair pros in Lamoure, ND

You may end up with extra wallpaper once your project is finished. Hang on to that wallpaper, as you may need to use it to patch up areas that get damaged later on. If you have a lot of excess wallpaper, try getting creative with it. You can use it to line the inside of a cabinet or drawers, for example.

If you can already see the texture of the existing wallpaper through the layer of paint, then the texture could also come through the new layer of wallpaper. If that’s the aesthetic you want, then proceed. But if you want a smoother surface, you should either strip off the existing paint and wallpaper or hang a layer of liner paper before proceeding.

You can hide wallpaper seams when painting by applying joint compound over them and then sanding thoroughly until smooth. You’ll want to apply two layers of compound, allowing for four to eight hours between coats. Do a light sanding between coats and then after the final coat is dry. Once the compound dries completely, you can begin priming and painting the wall.

While you could conceivably select any paint finish, paintable wallpaper tends to look its best with a flat or eggshell finish. A higher gloss paint might make the texture pop more, but it can look a bit dated once the paint has dried. And don’t worry about whether a water-based latex paint will loosen the wallpaper. Paintable wallpaper has a coating that prevents this from happening, so using latex paints without applying an oil-based primer to seal things first is fine.