Get matched with top bathtub restoration pros in Kenmare, ND

Two alternatives to reglazing are installing a bathtub inlay or a bathtub liner. An inlay is a low-priced mat that adheres to the bottom of a bathtub or shower. It’s useful for sealing minor leaks and concealing damage on the bottom of a tub. On the other hand, a bathtub liner is essentially a protective casing that goes over the entire tub. They are usually custom-fit and cost more than reglazing yet don’t last as long.

Costs vary by materials used, surface size, and complexity. Refacing can be cost-effective compared to full replacements, with an average range between $300 and $1,200.

While tubs are fairly sturdy, you may notice cracks or holes. This kind of damage can happen from someone accidentally dropping something heavy into the tub. You might also see damage if you drop something heavy into the tub over and over again (like your extra large bottle of body wash). While you might only notice a small dent at first, this can later turn into a crack or a hole.

Also, certain cleaners that are harmful to your tub can cause damage. And if you have a fiberglass tub, you might see cracks if it was not installed properly with the right support.

Most homeowners need to wait at least two days, sometimes three, to use their bathtub following the reglazing process. That’s the normal length of time it takes for epoxy resin to cure. There are quick-dry epoxy kits available that cure in 12 hours, though. To ensure that the epoxy dries properly, try to ventilate the bathroom as well as you can.