Top-rated floor polishers.

Get matched with top floor polishers in Ellendale, ND

Enter your zip and get matched with up to 5 pros

Need a pro for your floor polishing project in Ellendale, ND?

Select your specific project to find the pro for you.

Find Floor polishers in Ellendale

Floor Polishers questions, answered by experts

Services typically take 2-4 hours, depending on the area size and floor material.

You can embrace minimalism when it comes to cleaning vinyl plank flooring. Water or diluted vinegar both work great for mopping and are much better options than some other cleaners that can damage the protective coating on these floors. Ammonia or solvent-based polishes can both break down the top layer. Also, avoid “mop-and-shine” cleaners, which tend to leave behind residue on vinyl plank floors.

To properly maintain and care for hardwood floors without damaging the finish, establish a regular cleaning routine. Sweep with a broom or microfiber dust mop daily, or vacuum weekly, to remove dirt and debris that can scratch the surface; be sure to clean in tight corners and under furniture. For a deeper clean, use a damp mop with a cleaner specifically designed for hardwood floors, but avoid using harsh chemicals or excessive water, as this can damage the wood. You can further protect your floors by placing mats at entryways to catch dirt and moisture and putting felt pads under furniture legs to prevent scratches. For long-term care, refinish the floors as needed to keep them looking their best.

You can use dish soap mixed with warm water to clean just about any type of flooring, and while vinegar is a great addition to some floor cleaners, it’s not a good idea to use it on wood flooring or engineered wood flooring. Vinegar is very acidic, and it can gradually eat away at the protective finish on wood floors. If you’re cleaning laminate, tile, concrete, or vinyl floors, feel free to use vinegar and water in a 1-to-1 ratio with a few drops of dish soap. For wood floors, substitute the vinegar for olive oil.

The answer to this question depends on how large the room is and how much experience you have stripping and waxing floors. It will take at least 24 hours to strip the floors, then you must allow time for drying, waxing, waiting for them to cure, and, finally, buffing them. Since you likely will not be working for the full 24 hours, it is safe to say that this is a two- or three-day job.

The Ellendale, ND homeowners’ guide to floor polishing services

From average costs to expert advice, get all the answers you need to get your job done.