Get matched with top pressure washers in Bowman, ND

Yes, you can pressure wash epoxy garage floors. Most epoxy floors can be cleaned with a mop, but you may choose to pressure wash your floor if it is stained, has ground-in dirt, or is covered with mold or mildew. Before pressure washing, soak stains and dirty areas with a gentle cleanser for best results. Then use a pressure washer tip angled at 45 degrees and raise the spray nozzle to at least 18 inches off the floor to protect the flooring surface. You can also use a surface cleaner power washer or rotary scrubber to prevent overspray. 

Yes, you can pressure wash gutters to remove debris, dirt, and grime, but it should be done with care. High-pressure settings can bend or dent aluminum gutters and potentially damage your roof, so it’s typically best to use a lower-pressure setting or a nozzle that disperses water over a wide area to minimize the risk of damage.

This process doesn’t necessarily require soap or detergent, but it definitely helps. You can get by with just using water, but remember, brick requires a lower-than-average pressure level when compared to concrete, so forgoing detergent increases the time it takes to spot clean stains and debris once you finish with the pressure washer. Brick is especially porous, so the less water you use on it, the better.

Powerwashing services for businesses typically range from $200 to $1,500, depending on surface size, level of grime, and cleaning methods. Heavily stained or high-rise buildings may require additional labor and equipment.