Get matched with top drain cleaners in Laurel Springs, NC

On average, a plumber will take 30 minutes to two hours to clear a clogged drain. If the clog is located close to the drain or an access point and isn’t severe, the project will take about half an hour. If the clog is deep within your plumbing system or is a severe blockage, it can take two or more hours to remove the clog. For this reason, main line clogs tend to take longer, usually between two and three hours.

Yes—your local septic company can clean your septic leach lines with a sewer jetter, a device that pumps high-pressure water through the lines to blast out any clogs and scum buildup. Unless there’s a clog or blockage in the lines, however, you do not need to perform this maintenance regularly. Do not attempt to clean your own leach lines, as you could easily damage them, leading to very costly repairs.

To keep window wells from filling up with water, you need to stay on top of maintenance. Remove debris as it fills up, and regularly loosen the gravel at the base if it’s become compacted. You can also reslope your yard to make sure water flows away from the window well (and your home’s foundation), and you can even install a window well cover to prevent debris from building up. Installing an actual drainpipe at the base of the well can also prevent window well drainage problems.

A washing machine should drain the water used during its cycle through a drainpipe and out through the house’s plumbing. This is the same plumbing that sinks and shower drains run to, and if the U-bend is installed correctly, it shouldn’t smell. The total drainage from the house is then integrated into the city sewer system or, if you’re in the country, dispersed into a septic tank.