Best tv mount installation pros near Columbia, NC

It’s highly recommended to use studs for a TV mount. The last thing you want is to be watching your favorite show when the TV falls off the wall. Studs are much stronger than drywall and quite a bit stronger than drywall anchors but, if you can’t find the studs or there simply aren’t any where you need them, you can use drywall anchors. It’s extremely important to make sure the anchors are rated for the load of the TV. We recommend using anchors that are rated far beyond the weight of whatever you’re hanging. Our suggestion is metal drywall toggle anchors. 

The shorter the coaxial cable, the better. The further you run the cable, the more signal loss you'll experience. At 50 feet, you'll see significant signal loss, and by 100 feet, you'll experience at least a 30% drop in signal strength.

You will be placing holes in the wall to hang the mounting bracket. If you’re mounting a large TV, the bolts in use could make significant holes around half an inch in diameter. Other than a few holes, though, the process of mounting the TV should not cause significant damage to the wall, unless you make an error and miss the wall stud, tearing out drywall. Should you decide to remove the mount later, the DIY drywall repair cost for a small hole usually is $10 to $30. It’s a repair you can do in a few minutes.

In most cases, you should not put a TV on a fireplace mantel. The minimum width required to put a TV safely on a shelf or mantel is 10 inches, but pre-made mantels are usually too shallow, averaging at only seven inches deep. If you do choose to place a TV above a mantel, it should be mounted to the wall. However, do so cautiously as heat radiating from the fireplace could potentially cause damage to electronics.