Get matched with top above ground pool installation pros in Aulander, NC

Pool leaks most commonly occur at joints or where different materials meet. The most frequent leak spots include:

• The Pool Skimmer: Where the plastic skimmer meets the pool's liner or shell.

• The Pool Liner: Tears can develop in vinyl liners, especially those between 5 and 20 years old. Leaks also occur around the liner's edge.

• Fittings and Accessories: Areas around return lines, the main drain, and pool lights are common culprits.

• Pool Equipment: The pump, filter, and filter housing can also leak.

While leaks in underground pipes are less common, they can be costly to fix. It's usually best to check the more common spots before investigating the plumbing system.

Yes, adding a pool to your property will almost always increase your homeowners insurance premiums. This is because pools are considered a greater liability due to their potentially hazardous nature, and the added replacement cost of the pool is factored into your home's rebuilding cost when considering coverage limits. The amount of the increase can range from as little as $50 to a few hundred dollars more per year, depending on your insurance provider, location, current coverage, and the safety features installed. Before building a pool, it is highly recommended to contact your insurance agent to get an estimate, discuss their specific guidelines and requirements, and factor the increased premium into your total pool installation costs.

It takes more electricity to run one, so it’s not necessarily cheaper to run a salt water pool. However, the cost difference is relatively minor; it may cost an extra $50 over the course of a year. However, salt costs a lot less than chlorine sanitizers. This lowers the overall maintenance costs for a salt water pool compared to chlorine pools.

If your pool takes longer than one or two days to fill, you might be dealing with low water pressure. Using a water pressure gauge on your outdoor tap, you can check your water pressure. A reading of 40 psi or below is considered low. A leak, a nearby water shutoff, or several other reasons could cause this. 

If the water pressure isn’t a problem, you could have a low flow rate from clogs, corroded pipes, or other plumbing issues. It’s best to call in a local plumber to get to the root of the issue.