Best grout and tile cleaning pros near Terry, MT

Before you begin caulking a shower, you’ll need to use a utility knife or solvent to remove the old caulk and inspect the area for mold. If needed, take appropriate steps to get rid of the mold, then wipe everything down with dish soap and warm water before letting it dry completely. Finally, surround the caulking area with two strips of blue painter’s tape—one above the joint where you’re caulking and another below it.

Unless you have epoxy grout, you should reseal your grout after cleaning. This is especially true if you’re in a high-moisture area like your bathroom or kitchen. Sealing your grout has a lot of advantages, like helping your tiles last longer and making it easier to clean the grout the next time.

If you happen to skip this step, you’re likely to have grout problems down the road like cracking or grout falling out. You may also notice damage to your tiles.

Yes, you can use a mixture of 1 tablespoon of bleach and a gallon of warm water to clean stubborn stains from brick. Do not use bleach without diluting it in water. Undiluted bleach may cause discoloration. You can use either Oxygen bleach such as OxiClean or chlorine bleach. Always wear protective gloves and eye protection when handling bleach.

To clean stone tiles, first sweep or vacuum to remove dirt particles. Use a mild, pH-neutral detergent and warm water to mop. Be careful not to use acidic cleaning solutions, such as vinegar and lemon juice, which can damage the surface.