Get matched with top masons in Havre, MT

The material you use depends on how hard-wearing your steps need to be and what you want them to look like. The most common stone for exterior steps is bluestone. It’s hard-wearing and durable, and bluestone steps cost between $15 and $30 per linear foot. Limestone is also a popular option and is mid-range, costing $25 to $50 per linear foot. You should always consider the specific requirements of your project before ordering any materials.

You should generally drill into the mortar joints when installing shutters on brick. Mortar is softer, which makes drilling easier and puts less strain on your tools. It also lowers the risk of cracking a brick—something that’s a lot harder to fix. Mortar holds fasteners well enough for standard shutters, and if you ever need to patch the holes later, it’s a much simpler job than dealing with damaged brick. Just keep in mind that if your mortar joints are too thin or the hardware calls for brick anchoring, you'll need to check the manufacturer’s recommendations and adjust accordingly.

Brick spalling—which refers to the crumbly, flaky, or pitted appearance that can develop over time—is caused by a few different conditions. These include:

• Climates with constant freeze-thaw cycles

• Use of non-breathable sealants

• High-pressure water cleaning

• Improper installation

While you can’t do anything about the weather, you can preserve your bricks by cleaning them with soapy water and a good old-fashioned scrubbing. Pressure washers may be satisfying to use, but they can eventually wear away the surface of your bricks. If you don’t have advanced-level DIY skills in masonry, you can hire a reputable masonry contractor in your area for your project.

When painting brick, each application method has distinct advantages and disadvantages. Spraying is significantly faster but may not penetrate deeply beyond the surface layer. Rolling is effective for working paint into the brick's texture but can be less effective on mortar joints. If you opt for a roller, choose a thick nap of at least a half-inch to ensure paint gets into all the crevices for even coverage. Using a brush is generally not recommended as it is very time-consuming and provides poor surface penetration. Ultimately, a combination of spraying followed by back-rolling is often the best strategy for a durable and even finish.