Silicone-based caulk is known for its waterproofing qualities, so it’s the best option for any bathroom area. While it’s often more expensive, it will provide a better, longer-lasting seal than acrylic or latex caulk. Use it along the base of the toilet to prevent leaks and keep the area clean and protected.

Yes, you should screw your flange to the subfloor, including cement. The best way to get this done is to predrill holes into the concrete using a hammer drill and a ¼-inch concrete bit. Be careful when you’re ready to bolt your flange down, as you can accidentally crack it. You can avoid this issue by not installing the screws too deep. Or, you can opt for a flange with a stainless steel ring so you don’t have to worry about cracking the plastic.

Basement toilets don’t always need a pump. However, it is the most common setup because plumbing systems use gravity to move waste away from the home. Basement toilets often sit below the home’s main sewage system, and installing a sewage ejector pump pushes the wastewater and sewage up to the main sewer line. Alternatively, you can use an upflush or macerator toilet that breaks down the waste and pushes it straight to the main sewer line rather than via a sewer line from the bathroom.

Yes, you can clean a toilet tank with white vinegar. Before you do, shut off the water supply to the toilet. Then, flush it to empty the tank. Next, combine one part vinegar with one part water in a spray bottle and spray the mixture inside the tank. Let it sit for 10 minutes, then rinse away the vinegar by pouring clean water into the tank. Make sure the tank is empty, then dip a scrub brush in vinegar and clean the tank’s inside walls. Turn the water back on and flush again to rinse away the vinegar.