Get matched with top fire pit installation pros in Tutwiler, MS

Start by checking the top or side edge of the door. Look for a certification label or metal tag stamped with details like the fire rating and information on the manufacturer. Even if it’s painted over, the tag should still be visible. Next, look along the edges for slim intumescent strips. They’re designed to swell up and seal gaps when exposed to heat. Finally, check if the door closes itself. Most fire doors have a self-closing mechanism, like an overhead closer or spring hinges. If none of these are obvious, contact a fire safety professional to help verify your door. 

If a light switch is off, it’s very unlikely to cause a fire. For a fire to start, the switch has to be on, activating an electrical current, and the wiring must be faulty. However, the malfunctioning light switch could cause an intermittent current to move across the electrical wire. This issue could become a fire hazard with another device connected to the wire. You should replace the bad light switch as soon as you notice it or call an electrician.

A spark arrestor is not the same as a chimney cap. Both sit on the top of the chimney. However, the cap keeps debris from entering the chimney, and the spark arrestor’s primary function is to prevent burning embers from escaping. Some spark arrestors are integrated into the chimney cap, and others are installed separately.

No, a chirping smoke alarm is usually a sign of an issue with the power supply of the unit. This is easily solved by replacing the battery to stop the smoke alarm from beeping. If the chirp continues, review the owner’s manual to determine the cause. These chirps are short and not as loud as the beeping of the alarm itself. If you can’t tell the difference, it’s best to treat it like an activated alarm until you find the cause.