Top-rated drain pipe installers.

Get matched with top drain pipe installers in Bolton, MS

Enter your zip and get matched with up to 5 pros

Need a pro for your drain pipe installation project in Bolton, MS?

Select your specific project to find the pro for you.

Find Drain pipe installers in Bolton

Avatar for Powell Plumbing Co.
Powell Plumbing Co.
5.0(
19
)
Basement Drainage Channels - InstallSump Pump or Interior Foundation Drains - Install

Serving Bolton, MS and surrounding areas

In business since 2008

Free estimates

Emergency services offered

"This was a very involved remodel job with three bathrooms and kitchen, new water lines, and replacing a lot of sewer pipes under the house. Great, knowledgeable plumbing work, but sometimes delayed in coming to the job due to other clients needing help also."
Additional Photos
Additional Photos
Additional Photos
Additional Photos
Additional Photos

+7

Response time10 hrs
Response rate100%
Recommended by100%of homeowners
Drain Go Plumbing
4.1(
89
)
Basement Drainage Channels - InstallSump Pump or Interior Foundation Drains - Install

Serving Bolton, MS and surrounding areas

In business since 1996

Free estimates

Credit card accepted

"They (Jeff and Joe) arrived early in the day, earlier than I had hoped for. And attempted to unclog the drain from within the wash room. That did not work.



He informed he could attempt to unclog the drain from the vent stack to the washer but that the agreement with AHS would not cover that cost. He told me it would ne and additional $225.00, but that if he was unable to unclog the drain it would not cost me anything. I agreed to that. They worked around three hours and were eventually successful in unclogging the drain, very happy with the results, worth the cost.



The workers were respectful, on-time, professional and did a great job. I will definitely use Drain Go Pluming again.
"
Recommended by77%of homeowners
...
Showing 1-10 of 78
Drain Pipe Installation questions, answered by experts

Yes, you can pour water down the toilet to help it flush. For each flush, you’ll need 1 to 2 gallons of water for newer toilets or 3 to 5 gallons of water for older toilets. Rather than dumping the entire bucket in all at once, pour the water in slowly for the best results. If you’re pouring water down the toilet to help it flush after a clog, only use 1 gallon of hot water.

To unclog a plumbing vent, you first need to locate it. Look at your home's roofline. The plumbing vent will be a vertical pipe sticking straight up from the roof. Since this pipe runs all the way to the main drain underneath your house, you should also be able to find it in the attic.

It’s sometimes difficult to distinguish a clog from a frozen drainpipe since ice technically causes a clog. If the temperature doesn’t tip you off, there are a few additional signs that your pipe is frozen. Look for condensation and frost around the pipes. Ice in pipes can cause a banging or clanking noise as opposed to a clog from a softer material.

Costs depend on clog severity, pipe condition, equipment required, and labor.

Plumbers use a variety of tools to help unclog the toughest of drain clogs, but the most common tools they use are drain snakes and augers. They try a plunger or drain snake to start, then move to heavy-duty augers, and finally try using a hydro jetter to blast away the clog with high-pressure water. Hiring a plumber to unclog a drain costs $125 to $300, largely depending on the extent and location of the clog and which of these methods is best for clearing it.

The Bolton, MS homeowners’ guide to drain pipe installations

From average costs to expert advice, get all the answers you need to get your job done.