Get matched with top deck staining pros in Wheatland, MO

Yes, you can and should paint or stain pressure-treated wood to help prevent the boards from cracking. However, you must wait for the wood to dry out completely before applying any finish. Freshly treated wood can take weeks or even months to dry; a common recommendation is to wait three to six months. To check if the wood is ready, perform a simple water test: drip some water onto the surface. If the water beads up, the wood is still too wet and needs more time to dry. If the wood absorbs the water, it is dry enough to be painted or stained. You can proceed with building your deck or fence while the wood is still wet, but you will need to wait to apply the paint or stain.

Yes, it is generally a very good idea to seal your deck after pressure washing. Power washing removes not only dirt and debris but also a thin layer of wood, leaving the surface exposed and more susceptible to weathering. Sealing is almost always needed after this process. After a general cleaning, sealing isn't automatically necessary if the existing sealant is still intact. You can test the surface by placing a few drops of water on it. If the water beads up, the sealant is working. If it soaks into the wood, it's time to apply a new sealant. If it has been a few years, it's wise to remove the old sealant, wash the deck, and reseal for maximum protection.

Unless you’re using a 2-in-1 formula or painting over an existing coat of paint, it pays to apply a coat of primer ahead of your new paint. Decks see a lot of footfall and exposure to extreme and sudden temperature changes and moisture levels. The primer promotes better paint adhesion, moisture repellency, and a smoother finish, which means you’ll often need fewer coats of paint. 

When staining a deck, don’t skip surface prep, avoid staining damp or dirty boards, and don’t apply stain in extreme heat, cold, or wet conditions. Never overload the wood with a stain, as too much can cause tackiness or peeling. Also, don’t forget to test a small area first to ensure the color and finish look right.