Get matched with top epoxy flooring pros in Vienna, MO

Resurfacing a garage floor takes about eight hours on average, with another couple hours over three days to do the epoxy. Epoxy goes on in three coats, with each coat taking 24 hours to dry and cure. You’ll need to keep foot and vehicle traffic off of your garage floor for around 4 days in total when replacing your garage floor, so be sure to plan ahead before you start. This is a great time to organize your garage since you’ll need to move everything out to apply the epoxy.

Most garage floor paints are epoxy-based and available in DIY kits. One-part epoxies are simpler to apply than two-part epoxies, which have a more involved process. Sometimes, people also use latex-based paint because it’s easier to clean up mistakes with soap and water. Either way, make sure your paint is specifically designed for concrete garage floors. It should say so on the label.

Yes, you can seal old concrete, but proper preparation is essential. Before sealing, ensure the concrete is clean, dry, and free of any old sealant. To check if resealing is necessary, place a few drops of water on the surface; if they are absorbed in less than five minutes, it's time to reseal. If you are using the same type of sealer that was previously applied, you may not need to remove the old layer. However, if you are applying a different type of sealer, the existing one must be removed. Additionally, repair or fill any cracks to create a smooth base before you begin sealing.

Driveway installation is challenging. While chip seal might sound easier to apply than asphalt, the process still involves heavy machinery and professional skills. Unless you come from a construction background, we recommend hiring an asphalt company to chip seal your new driveway. If you are paving the driveway entirely with chip seal, expect to pay $5 to $10 per square foot.