Top-rated well and pump technicians.

Best well and pump technicians near Cabool, MO

Enter your zip and get matched with up to 5 pros

Need a pro for your well and pump service project in Cabool, MO?

Select your specific project to find the pro for you.

Top-Rated Well and pump technicians in Cabool - Updated Nov 2026

Bryson Grabher Pump Service
5.0(
5
)
Well Pump - Install or ReplaceWell Pump - Repair or Service

Serving Cabool, MO and surrounding areas

Approved

In business since 1975

Free estimates

Emergency services offered

At Bryson Grabher Pump Service, our company is based on the belief that our customers' needs are of the utmost importance. Our team is committed to meeting those needs. We welcome the opportunity to earn your trust and deliver you the best service. No job is too big or too small for our experienced team. Call today for a quote. \n

Response time1 day
Response rate87%
Recommended by100%of homeowners
Avatar for Choice Home Warranty
Choice Home Warranty
4.0(
5,680
)
Well Pump - Install or ReplaceWell Pump - Repair or Service

Serving Cabool, MO and surrounding areas

In business since 2008

Emergency services offered

Credit card accepted

"Went well to this point of replacing parts. Then the United needed to have a system leak test and then needed freon put in pump. This was refused by Choice warranty. We were left with a partial repair and a heat pump not able to do it's job."
Recommended by81%of homeowners
Avatar for American Home Shield – Home Warranty
American Home Shield – Home Warranty
3.5(
5,689
)
Well Pump - Install or ReplaceWell Pump - Repair or Service

Serving Cabool, MO and surrounding areas

In business since 1971

Credit card accepted

"Rather than fix the issue the first 2 calls, more refrigerant was pumped into the system. This cost me $75 for each call plus the cost of the refrigerant. The 3rd time, they fixed a valve and refilled the refrigerant and I am monitoring to see if this really fixed the problem. So I am out $225 for service calls fro the same problem and the cost of the refrigerant. I think they take this approach intentionally."
Additional Photos
Additional Photos
Additional Photos
Additional Photos
Additional Photos

+2

Recommended by65%of homeowners
RAA Plumbing, Extermination and More, LLC
New to Angi
Well Pump - Install or ReplaceWell Pump - Repair or Service

Serving Cabool, MO and surrounding areas

In business since 2007

Free estimates

Our mission at RAA Plumbing, Extermination and More, LLC is to continue the growth of our business by doing right by all of our clients. We love seeing that one of a kind smile on a home owners face at the end of a project! RAA Plumbing, Extermination and More, LLC stacks up with the competition and surpasses it with competitive prices, second to none workmanship and a prompt/responsive team! We give you quality that you can measure, and a finished product that will enhance your home forever. Call us today!

Wells and Pumps FAQs, answered by experts

Most well pump pressure switches have a factory setting of 30 to 50 PSI. There’s some flexibility with this if you’d like a lower or higher water pressure, but remember that it should sit 2 to 3 PSI above your well tank’s general pressure setting.

The inside of your pressure switch cover will usually indicate minimum and maximum settings—going below and above the numbers might damage your well pump.

Schedule annual inspections, monitor water pressure, and address minor issues promptly to avoid major repairs.

If you notice that your well pump runs continuously, it’s important to take action quickly to avoid further damage. A few common issues may be to blame for a continuously running well pump, such as mechanical damage, a faulty pressure control switch, low water level, prime loss, and leaking pipes and fixtures.

For the most part, choosing between 30/50 psi and 40/60 psi is based on your water-pressure preference. However, it can also depend a little bit on your house—if you have older plumbing, a lower water pressure can be easier on the pipes (and a bit more gentle on your well pump). 

The lower 30/50 pressure is usually enough for a single-story home, but you may want 40/60 if you have multiple stories, as the extra pressure helps water flow smoothly up to the second floor.

Yes, you can shock a well yourself, but it can be dangerous if you don’t know what you’re doing. We recommend calling a pro, but if you decide to do it yourself, make sure to follow proper safety precautions. This means wearing the correct safety gear, such as rubber gloves, goggles, and boots. You should also mix the chlorine solution in an open area with plenty of ventilation. Also, make sure not to drink or use the water for a few days afterward, until you’ve flushed the system and retested the water.

The Cabool, MO homeowners’ guide to well and pump services

From average costs to expert advice, get all the answers you need to get your job done.