Top-rated well and pump technicians.

Best well and pump technicians near Rolla, MO

Enter your zip and get matched with up to 5 pros

Need a pro for your well and pump service project in Rolla, MO?

Select your specific project to find the pro for you.

Top-Rated Well and pump technicians in Rolla - Updated Nov 2026

Avatar for Choice Home Warranty
Choice Home Warranty
4.0(
5,680
)
Well Pump - Install or ReplaceWell Pump - Repair or Service

Serving Rolla, MO and surrounding areas

In business since 2008

Emergency services offered

Credit card accepted

"Went well to this point of replacing parts. Then the United needed to have a system leak test and then needed freon put in pump. This was refused by Choice warranty. We were left with a partial repair and a heat pump not able to do it's job."
Recommended by81%of homeowners
Avatar for American Home Shield – Home Warranty
American Home Shield – Home Warranty
3.5(
5,689
)
Well Pump - Install or ReplaceWell Pump - Repair or Service

Serving Rolla, MO and surrounding areas

In business since 1971

Credit card accepted

"Rather than fix the issue the first 2 calls, more refrigerant was pumped into the system. This cost me $75 for each call plus the cost of the refrigerant. The 3rd time, they fixed a valve and refilled the refrigerant and I am monitoring to see if this really fixed the problem. So I am out $225 for service calls fro the same problem and the cost of the refrigerant. I think they take this approach intentionally."
Additional Photos
Additional Photos
Additional Photos
Additional Photos
Additional Photos

+2

Recommended by65%of homeowners
Total Home Care Mid-MO
New to Angi
Well Pump - Repair or Service

Serving Rolla, MO and surrounding areas

In business since 2022

Free estimates

Emergency services offered

Total Home Care Mid-MO is committed to excellence in every aspect of our business. We uphold a standard of integrity bound by fairness, honesty, and personal responsibility. Our distinction is the quality of service we bring to our customers. Accurate knowledge of our trade combined with ability is what makes us true professionals. Above all, we are watchful of our customers' interests, and make their concerns the basis of our business.

Wells and Pumps FAQs, answered by experts

How do you set your well’s pressure tank? All you need to do is first drain the tank of water and find the pressure switch. Remove the switch cover and adjust the switch with a wrench—clockwise to increase water pressure, and counter-clockwise to reduce it. Each complete turn of the nut on the switch should equal 2.5 psi. Once this is done, replace the switch cover. All that’s left is to adjust the pressure of the tank itself using an air compressor and a tire gauge to support the new setting.

A water pressure booster doesn't require special maintenance. Like any house system, inspections should be a regular part of your annual schedule. Check for leaks, faulty valves, pressure loss, and mineral build-up. Pressure loss could be a result of mineral build-up, and you can descale the system with a vinegar and water solution.

For the most part, choosing between 30/50 psi and 40/60 psi is based on your water-pressure preference. However, it can also depend a little bit on your house—if you have older plumbing, a lower water pressure can be easier on the pipes (and a bit more gentle on your well pump). 

The lower 30/50 pressure is usually enough for a single-story home, but you may want 40/60 if you have multiple stories, as the extra pressure helps water flow smoothly up to the second floor.

No. Well pump replacement is not recommended as a DIY project, particularly if you have a deep well and a submersible pump. Plumbing and electricity are best left to the pros, especially when something like your well pump includes both. Even when troubleshooting your pump, it pays to have a partner standing by for your assistance and safety.

The cost to replace a well-pump motor will depend on the size, but this repair is often as costly as installing a new pump. Generally, a well-pump replacement will cost between $950 and $2,650, with an average of $1,800. Other factors like pump type and pipework will impact your final cost.

The Rolla, MO homeowners’ guide to well and pump services

From average costs to expert advice, get all the answers you need to get your job done.