Get matched with top pressure washers in Cabool, MO

A pressure washer’s size or power is measured in pounds per square inch (PSI). The amount of pressure you need will depend on your project and the material you’re washing, but consumer pressure washers range from 500 to 2,400 PSI. Porous materials like brick and stucco should not be blasted with anything stronger than 1,000 PSI, while you can use a PSI of up to 2,400 to clean a vinyl fence.

Whether you need to winterize your pressure washer depends on where you store it. If you can keep it in a relatively warm place with no risk of freezing, you won't need to add antifreeze. However, if the machine will be stored in freezing temperatures, any liquid left in the water pump can freeze, expand, and cause severe damage. To prevent this, add antifreeze to keep it in good condition. While some suggest emptying the machine with compressed air, this can be a tedious process that may not fully drain the liquid. Regardless of storage conditions, it is also good practice to empty the gas chamber and refresh the oil before winter storage.

This answer is a bit tricky because experts say both. You should apply your cleaning solution from bottom to top, but rinse from top to bottom to avoid streaking. When it comes to multi-story houses, you’ll want to start at the top floor and work your way down, but follow the above instructions for each level as if it were an independent structure, rather than washing the whole house as one unit.

If you don’t use the right PSI setting for your fence’s material, then yes, pressure washing can ruin your fence. Specifically, if you use a PSI that's too powerful, you may permanently damage a fence. Pressure washers can also remove paint from fences, though this can be a great thing if you’re looking to restore an old wood fence.