Get matched with top pressure washers in Appleton City, MO

Yes, most pressure washing companies use your home's water supply, typically from an outdoor spigot. However, some companies can bring their own water in a tank or truck. This is less common and may incur additional costs for filling and hauling the water. It's a good idea to ask a company which method they use when you call for a cost estimate.

Your deck may look or feel fuzzy after pressure washing because the high-pressure spray tears some wood fibers as it removes the outer layer of dead and discolored wood. This fuzzy effect is a normal part of the pressure-washing process and will go away on its own in a few weeks. You can opt to spot-sand your deck if you’d like to remove it more quickly.

You should wait until your pavers have completely dried and cured before pressure washing them. Wait at least three to five days, though some sealants may need up to an entire week. Rushing that timeline can mess with the finish, weaken the seal, or leave streaks that are tough to fix. Once the sealant has fully set, stick to a gentle approach. Keep the pressure under 1,500 PSI and hold the nozzle at least two feet from the surface. Anything stronger or closer can blast the joint sand loose or wear down the sealant you just applied.

Yes, you can use a pressure washer to effectively clean debris, dirt, and grime from your gutters, but it must be done with caution to avoid damage. Always use a low-pressure setting, with a recommended range between 1,200 and 1,800 PSI. Excessive pressure can bend or dent aluminum gutters, damage seams, peel paint, or even knock shingles off your roof, potentially leading to leaks and moisture issues. For a safer alternative, consider soft washing or cleaning them by hand. When using a pressure washer, it is safer to use gutter elbow extensions from the ground rather than climbing a ladder, as the force can cause instability. Due to the risks, you may want to hire a licensed and insured contractor for the job.