Get matched with top mailbox repairers in Saint Cloud, MN

There are a few reasons that a drawer won't come out. Most of the time, there's an obstruction of some sort preventing the drawer from acting normally. The key to figuring out the problem is investigation and patience. 

If possible, open the drawer as far as it will go and shine a flashlight inside to see if something in the drawer is hitting the cabinet frame. Or, remove a drawer above or below the offending one and use the flashlight to investigate the drawer slides. Discovering the cause will likely provide the necessary information to develop a solution.

The weight capacity depends on the construction method and the quality of the hardware.  Basic side-mount slides often support 50 pounds, but less expensive versions may be rated lower. Properly built drawers with dado joints and heavy-duty, full-extension slides can typically support between 75 and 100 lbs. Be sure to check the manufacturer’s weight rating for your specific drawer slides.

Fixing a drawer that is sticky, askew, or broken depends on the specific problem. Start by removing the drawer and examining the slides and tracks for any damage, bent parts, or loose hardware.

For minor issues:

• Clean and Lubricate: If the slides are just sticky, clean them and the corresponding tracks with a hot, damp cloth. Then, apply a lubricant like silicone spray or bar soap to help them glide smoothly. Also, check any roller wheels for problems.

• Tighten Screws: Tighten any loose screws on the slides and tracks. If screw holes are stripped, you may need to fill them and re-drill.

For more significant damage:

• Bent Hardware: If a slide is bent, you may be able to remove it, straighten it out, and reinstall it.

• Broken Parts: If a slide or track is broken or severely damaged, it will need to be replaced. Unscrew the damaged part and install a replacement that matches the type and size of the original.

After performing the repair, reinsert the drawer and test it to ensure it opens and closes smoothly, making any final adjustments for proper alignment. It can also be helpful to consult the manufacturer's guidelines for your specific drawer system.

Yes, you can repair cat scratches on leather furniture. A quick fix that won’t repair roughness is a leather recoloring balm that helps scratches blend in. Otherwise, use the following process.

1. Clean the area and trim loose fibers.

2. Rub leather binding glue all over the affected area.

3. Sand the area down with fine-grit sandpaper and clean off any residue.

4. Fill holes, scratches, and gouges with leather putty from a leather repair kit.

5. Sand the area down again and clean off any residue.

6. Apply leather colorant in several layers.

7. Seal the color in with a leather sealant and finish.