Top-rated welders.

Get matched with top welders in Richmond, MN

Enter your zip and get matched with up to 5 pros

Need a pro for your welding project in Richmond, MN?

Select your specific project to find the pro for you.

Verified Reviews for Welding pros in Richmond, MN

*The Angi rating for Welding companies in Richmond, MN is a rating based on verified reviews from our community of homeowners who have used these pros to meet their Welding needs.

*The HomeAdvisor rating for Welding companies in Richmond, MN is a rating based on verified reviews from our community of homeowners who have used these pros to meet their Welding needs.

Last update on October 27, 2025

Find Welders in Richmond

Avatar for main offroad welding
main offroad welding
4.5(
2
)

Serving Richmond, MN and surrounding areas

In business since 2016

Free estimates

Emergency services offered

"They were great and looks good. They work and beyond. I have no problem recommending them and will use their service again. Everybody uses main Offroad will be satisfied."
Additional Photos
Additional Photos
Additional Photos
Additional Photos
Recommended by100%of homeowners
Request Quote
Avatar for JD Metal Fab
JD Metal Fab
5.0(
2
)

Serving Richmond, MN and surrounding areas

In business since 2022

Free estimates

Offers commercial services

"Did our 316 stainless piping for Agri Systems. He was hard to get a hold of and had some scheduling conflicts but exceeded our deadlines and did great work. Seemed very knowledgeable. Will be doing expansion work for us in the future."
Response time6 days
Recommended by100%of homeowners
Request Quote
Welding questions, answered by experts

Yes, you can cut plexiglass by hand using a sharp knife or blade (utility knife, box cutter, glass cutter, etc.).

There are a few things you can ask welders before you hire them to get an idea of their experience and ability levels:

  • Are you licensed and certified?

  • How long have you been in the welding business?

  • Do you commonly do the type of welding I need?

  • Do you offer any kind of warranty for your work?

  • Do you charge by the hour or by the project?

  • How long do you expect my welding project to take?

  • What steps do you take to minimize errors in your work?

It will likely take an experienced pro less than an hour to install a ground rod, which is another reason why letting them handle the job is such a good idea. Safety concerns aside, it would likely take you much longer to install a ground rod if you decided to take this one as a DIY job.

Cutting rectangular ductwork requires careful measurements and the right technique. Use a measuring tape and pencil to mark the cutting lines accurately. Tin snips are excellent for straight cuts on smaller ducts. For more extensive or thicker rectangular ducts, a reciprocating saw with a metal-cutting blade is effective. 

Ensure the duct is well-supported and secure while cutting to prevent wobbling and maintain precision. After cutting, use a metal file to smooth any sharp edges, ensuring safety during installation. 

While a high-speed circular saw will cut through metal, and even cut through multiple sheets at once, the fast-spinning saw blades create a lot of heat. This heat can damage paint and other protective coatings, leading to serious problems like rust over time. The cost to paint a metal roof again to avoid this damage is typically an additional $0.50 to $1 per square foot.

The Richmond, MN homeowners’ guide to welding services

From average costs to expert advice, get all the answers you need to get your job done.

See all articles

What do you need done? We’ll find top pros.
  • 🌱 "Mow a small front yard"
  • 🛠 "Fix a leaking pipe under the sink"
  • 🏠 "Repair shingles on an asphalt roof"