Top-rated deck maintenance specialists.

Get matched with top deck maintenance specialists in Mountain Iron, MN

Enter your zip and get matched with up to 5 pros

Need a pro for your deck maintenance project in Mountain Iron, MN?

Select your specific project to find the pro for you.

Find Deck maintenance specialists in Mountain Iron

Tony Romanellis Handyman Service
New to Angi
Deck, Fence, Patio or Porch - Clean and SealDeck, Fence, Patio or Porch - Clean and Seal - For Business

Serving Mountain Iron, MN and surrounding areas

In business since 2011

Free estimates

Emergency services offered

Tony's Handyman Service My name is Tony Romanelli.I was born in St.Paul,MN.I have lived in the Grand Rapids area all my life. \n I have been doing carpentry work since i was fifteen years old. With my dad, after school.I have built custom decks,additions,sheds,roofing,siding etc.I live by my dad's rule,if you can't do the job right then don't do it at all.I guarantee all my work!

Tony and  Ron
Current project a 198 sq. ft. shed
 roof construction
 All treated floor on treated post
Roof had no overhangs

+5

Showing 1-10 of 35
Deck Maintenance questions, answered by experts

The best and fastest way to remove paint from a deck often involves combining a chemical stripper with a pressure washer. Gel-based paint strippers are highly recommended because their thick consistency makes them less messy and easier to apply than liquid strippers. After applying the stripper to loosen the paint, you can use a pressure washer to efficiently wash away the residue. When using a pressure washer for this task, it's important to use a low pressure (under 1000 PSI) to avoid forcing too much moisture into the wood, which could lead to mildew or rot.

Yes, you can build a deck around a fire pit, as long as it is safely enclosed, meets code requirements, and is at least 15 feet away from your home. You’ll want to ensure you have a heat-resistant barrier between the fire pit and your deck to prevent any structural damage and fires. A galvanized ring surrounded by pavers, brick, or stone makes for a beautiful, safe, and sturdy design.

In most cases, sanding an old deck before staining it is necessary to achieve a decent finish. If your old deck has a relatively new stain finish on it and you're only doing touch-ups, you can generally skip the sanding part. However, if your goal is to make the deck look and function better, sanding first is a must. 

PVC decking can get slippery when wet because it’s made from plastic. However, composite and wood decking can also be slippery when wet. It’s best to wear shoes with grippy soles when walking on a wet deck, no matter the material, and to be extra cautious not to slip and fall down.

There are approximately 5.33 board feet in a 2x4. You can use the board foot calculator in this article to easily find the answer. A 2x4 is 2 inches of thickness by 4 inches of width, so you need to find the length, with 8 feet being the most common. You’d use the calculator here to multiply 2 times 4 times 8, and then divide by 12, arriving at a total of 5.33 board feet. 

The Mountain Iron, MN homeowners’ guide to deck maintenance services

From average costs to expert advice, get all the answers you need to get your job done.