Get matched with top countertop and backsplash pros in Clarkfield, MN

There are several significant differences between laminate and quartz countertops. Quartz is much pricier than laminate but can last for decades, while laminate lasts around 15 years. Laminate can’t be repaired or resealed and is easier to damage than quartz, which can be repaired. Both quartz and laminate are prone to heat damage. Usually, the choice comes down to your budget.

It is not recommended to put a hot pan directly on a marble countertop. While marble is heat-resistant, it is not completely heat-proof, and extreme or prolonged exposure to high heat can cause discoloration, cracking, or chipping. Pans may also scratch or nick the surface. To protect your countertop and maintain its integrity, always use trivets or hot pads. Note that faux marble finishes do not resist heat and require protection from hot items at all times.

Yes, Corian® and other solid surface countertops can be cut with standard woodworking tools like a circular saw or a jigsaw, but using the correct blade is crucial for the best results.

The recommended blade is a tungsten carbide-tipped blade, often called a solid-surface planer or triple chip grind blade. This type of blade is hard enough to cut through the material effectively. For a jigsaw, a fine-tooth down-cutting blade should be used.

It is important to note that a diamond blade is not necessary. Diamond blades are designed for harder materials like natural stone, concrete, or brick, and Corian is not a natural stone.

Using blades designed for wood is not recommended as they can cause microfractures that weaken the countertop's edges. While a tungsten carbide blade provides a much cleaner cut, the resulting edge will still be rough and must be sanded and smoothed to prevent microfractures from developing over time.

Yes, laminate (or Formica) countertops often come in precut sizes. It is important to measure your space and then do some research, or take the measurements to a local home improvement store to see if you can get the right size. If you do get precut laminate countertops, you may still have to cut holes for the sink and fixtures.