Best water heater pros near Akeley, MN

Most hot water heater manufacturers recommend replacing the anode rod about once every three to five years. Anode rods sacrifice themselves by collecting iron, limestone, and other minerals that would otherwise corrode your hot water heater tank. This abuse wears them out long before your water heater does. Check the rod when you remove it and replace it if more than 50% of the metal has been consumed. Check the rod more frequently if you have hard water or use a water softener. 

No, boilers and water heaters are not interchangeable because they serve different primary functions. Boilers are used for central heating systems, providing hot water or steam to heat your home. In contrast, a water heater's purpose is to supply hot water for daily household use, such as for faucets and showers. A water heater alone cannot supply the warm water or steam needed for a central heating system.

While they are not interchangeable, it is common to have both a boiler and a water heater. In fact, a conventional boiler often works best when a water heater system is already in place. The two systems can be combined to provide both heating and hot water, either by pairing a boiler with an indirect water heater or by installing a premade combination boiler-water heater unit. For home heating, some homeowners may also opt for a furnace instead of a boiler.

Yes, you can convert a gas water heater to an electric one, but it is a complex process. You will need to ensure there is adequate power for the new electric unit, as they require more power than gas models. The project also involves safely closing off the gas lines and ventilation, and some cities may require a permit for the conversion. The cost can range from $1,500 to $4,100, depending on the installation scope, plumbing and electrical work, and the water heater model. For an accurate quote, it's best to contact a local professional. Also, be aware that your monthly utility bills may increase after the conversion, as natural gas is typically cheaper than electricity.

A water heater is one of the heaviest hitters in your home, and it needs as much power as possible to help it run efficiently and effectively.

Your water heater should be on its own dedicated circuit breaker, with no other power sources running to it. This is required to meet the National Electric Code–and to ensure it runs as efficiently as possible.