Top-rated generator install pros.

Get matched with top generator install pros in Crystal Falls, MI

Enter your zip and get matched with up to 5 pros

Need a pro for your generator install project in Crystal Falls, MI?

Select your specific project to find the pro for you.

Find Generator install pros in Crystal Falls

Avatar for Swick Heating Cooling Plumbing & Electrical
Swick Heating Cooling Plumbing & Electrical
4.0(
6
)
Fixed Generator - InstallFixed Generator - RepairGenerator - Install - For Business+1 more

Serving Crystal Falls, MI and surrounding areas

Approved (Corporate)

In business since 1977

Free estimates

Emergency services offered

Swick provides home services to Marquette, Negaunee, Ishpeming, Munising and the greater area of the Upper Peninsula of Michigan. Our services include Heating & Cooling, Electric, Plumbing, Electric Stove & Fireplace and related home services. Quality doesn't cost, it pays!

63 neighbors recently requested a quote
Generator Install questions, answered by experts

If you have a transfer switch properly installed, the generator and main electrical power cannot feed the system at the same time. However, you should still shut off the power at your main circuit breaker panel before activating the generator. If you do that, you’ll simply need to shut off the generator and reset your circuit breaker once the local power comes back on.

In many cases, yes. There are models called dual-fuel generators and fuel switches, but only between certain types of fuel. For example, with the right setup you can convert a generator from natural gas to propane. Some allow switching between diesel and gasoline. There are even tri-fuel generators available in some cases, which adds a large layer of security if you are worried about fuel availability in times of crisis. Always check your generator capabilities and manual instructions before trying to switch fuels. Some generators can use another fuel but may need a fuel conversion kit to prep them first.

It might seem counterintuitive, but installing a generator transfer switch will save you money in the long run. While you’ll have to pay between $400 and $2,500 to have the transfer switch installed, you’ll recoup that amount later on when you don’t have to pay for expensive repairs to your appliances, devices, and electrical system that may have burned out, overloaded, or stopped working due to a sudden loss of power or an incorrect hook up of a generator to your home

Sizing a generator is a careful process that requires calculating the electrical load of your entire house. You have to take into account every device you want to use and their wattage requirements, plus the wattage needed to start them, and look for a generator that can safely run all that at around 80% capacity.

In more practical terms, a small home can run on a 10,000-watt generator (and if you only want to power a few key appliances, much less than that). A mid-sized home may need something between 15,000 and 22,000 watts. Larger homes require 25,000 watts or more. 

Potential benefits of using a natural gas generator include reducing your carbon footprint, lower likelihood of carbon monoxide exposure, budget-friendly operating costs, and low-maintenance, continuous fuel supply. Some possible drawbacks, though, include higher initial installation costs, dependency on a natural gas supply, and installation complexity. Keep in mind that pros and cons will vary based on the type and brand of natural gas generator. 

The Crystal Falls, MI homeowners’ guide to generator installs

From average costs to expert advice, get all the answers you need to get your job done.