Top-rated bathtub restoration pros.

Get matched with top bathtub restoration pros in Phillips, ME

Enter your ZIP and get matched with up to 5 pros

Need a pro for your bathtub restoration project in Phillips, ME?

Select your specific project to find the pro for you.

Find Bathtub restoration pros in Phillips

Avatar for American Tubs

American Tubs

2.33(
3
)

American Tubs

2.33(
3
)
Customers say: Terrific value
13 years of experience

American Tubs designs and manufactures a complete line of premium quality Walk-In Bathtubs that are ideal for people with Limited Mobility, Seniors, Disabled and people with pain, arthritis, stress and other debilitating conditions.

American Tubs designs and manufactures a complete line of premium quality Walk-In Bathtubs that are ideal for people with Limited Mobility, Seniors, Disabled and people with pain, arthritis, stress and other debilitating conditions.

Bathtub Restoration questions, answered by experts

When it comes to cleaning bathrooms, bleach usually comes to mind. But like ammonia, bleach can damage acrylic tubs. In fact, many tub manufacturers warn against using bleach on acrylic bathtubs, and doing so could void the warranty on your tub. Again, a gentler cleaner specifically made for acrylic tubs, or one of the homemade methods listed above, is your better bet here.

It’s substantially less expensive to reglaze a tub than to replace it. The average cost of reglazing a bathtub is between $400 and $700, but that range may be higher based on where you live and the type of tub you have. Meanwhile, if you want to replace the bathtub, you’re looking at $2,000 to $9,400, with the average close to $5,700.

There are a few ways to check whether your tub is fiberglass or acrylic. If your tub is a color other than white, then your tub is likely acrylic (as fiberglass tubs are usually white). Check to see if there is discoloration on the bottom of the tub, because if it’s yellowed, then you can be fairly sure it’s fiberglass.

Also, fiberglass tubs have thinner edges and are cool to the touch. Acrylic, on the other hand, is either room temperature or warm to the touch.

For a standard-sized bathtub with minor damage, it takes approximately 3 to 5 hours to refinish. It might take a bit longer if your bathtub refinishing contractor needs to fill in significant cracks or gouges. This is the same if you have a specialty tub, like an oversized bathtub—you can expect your pro to take a bit on the longer side.

If you don’t caulk your bathtub, then there won’t be a watertight seal between your bathtub and the wall tile surrounding it. As a result, water can seep into the wall and the floor and cause the perfect breeding grounds for mold and mildew. Not only does this require costly repairs, but mold can be harmful to those breathing it. 

The Phillips, ME homeowners’ guide to bathtub restorations

From average costs to expert advice, get all the answers you need to get your job done.

See all articles